Brake question an Input Thanks

[crawler nut]

Building a rig with rocks an pinion brakes, I have twin sticked a 205 an have bought a twin stick cutting brake set up, with a 1 in 2 out for the brake lines. Installed a new Wildwood master cyl. No booster. My question is could I come out of both front an rear brake ports on the master cyl to a Tee, go straight to the cutting brakes that would be my 1 in, an then run out of the cutting brakes 1 to the front an 1 to the rear? Thanks guys was wondering if I would have good brakes if I did this. Looking for some input

 

[showtime33]

Believe it'll work. I ran this setup before with rocks but my cutting brake was single lever. I plumbed it where you pushed forward to lock up front caliper and pulled back to lock rear caliper. You just run from master cylinder to cutting brake, then decide which lever you want for front plumb off it to front caliper then plumb off other to rear. With dual handle setup you could hold both if you ever needed. Use to run em in rail buggys all the time.