Yotacrawlin
Member
- Joined
- Dec 16, 2011
- Messages
- 7
I have a freshly built sbc 350 that i bought recently from a engine builder that builds engines for race cars. I purchanced it for my buggy build but decided to go a different route.
It is fresh never even fired up yet, its completely rebuilt and built engine that was originally built for a dirt track race car. Engine makes about 450hp
Reduced 2400 obo
SPECS
-010 High nickel block, bored .060 over 360ci, All new freeze plugs
-2 bolt main
-GM shot Peened rods, all new rod bearings
-Hypereutectic Flat top Pistions, with all new rings, wrist pins, clips etc all new
-High volume oil pump
-327 Camel Hump heads 64cc, All new factory valves that have had a 5 angle valve job done, Heads have been completely rebuilt and gone through, Stock porting altho these heads flow very well stock
-ARP head bolts
-Studs and poly locks
-Harland Sharp full roller rockers, aluminum
-Harland Sharp High rev springs
-Comp cam, 270H 270 duration 470 lift, new hydaulic lifters, and cam bearings
-New GM waterpump
-Double roller timing chain
-Carter high flow fuel pump with stainless steel lines
-Edelbrock Victor Junior Intake
-Holley 750 double pumper (used)
-MSD Flame Thrower Ignition
-8.5mm Spark Plug wires, new plugs
-High Torque mini starter
-Chrome Tall valve covers with breathers
-Painted chevy orange, but easily painted as i was planning to repaint it
704 651 7303 Brad
Located in Mint Hill Nc, near charlotte
Will consider partial trades for 42 inch tires with good life left, preferably pitbull rockers, suspension seats, 4-5 point harness, 8-10gal fuel cell, Link material 2 inch 250 wall dom tubing, general 4x4 stuff just no junk and really only lookin for a partial trade
It is fresh never even fired up yet, its completely rebuilt and built engine that was originally built for a dirt track race car. Engine makes about 450hp
Reduced 2400 obo
SPECS
-010 High nickel block, bored .060 over 360ci, All new freeze plugs
-2 bolt main
-GM shot Peened rods, all new rod bearings
-Hypereutectic Flat top Pistions, with all new rings, wrist pins, clips etc all new
-High volume oil pump
-327 Camel Hump heads 64cc, All new factory valves that have had a 5 angle valve job done, Heads have been completely rebuilt and gone through, Stock porting altho these heads flow very well stock
-ARP head bolts
-Studs and poly locks
-Harland Sharp full roller rockers, aluminum
-Harland Sharp High rev springs
-Comp cam, 270H 270 duration 470 lift, new hydaulic lifters, and cam bearings
-New GM waterpump
-Double roller timing chain
-Carter high flow fuel pump with stainless steel lines
-Edelbrock Victor Junior Intake
-Holley 750 double pumper (used)
-MSD Flame Thrower Ignition
-8.5mm Spark Plug wires, new plugs
-High Torque mini starter
-Chrome Tall valve covers with breathers
-Painted chevy orange, but easily painted as i was planning to repaint it
704 651 7303 Brad
Located in Mint Hill Nc, near charlotte
Will consider partial trades for 42 inch tires with good life left, preferably pitbull rockers, suspension seats, 4-5 point harness, 8-10gal fuel cell, Link material 2 inch 250 wall dom tubing, general 4x4 stuff just no junk and really only lookin for a partial trade
