Sold/Expired Dana 60 FF Rear 4340 Chromoly shafts

[ECGS]

We now have Rear flanges that will allow you to bore your spindle and run double spline dana 60,70,80 shafts. No front hub conversion necessary. Just bolt on the flange and give us your stock shaft measurement. We will have custom made 4340 or 300m shafts made for you. These shafts are made in america out of american stock with zero reported failures.

We also have Yukons Rear Full Float Cut to length 4340 chromoly shafts back in stock. These have 6 inch of splines and come in different lengths so you can customize for you rear 60 applications. Here are the lengths and prices

Yukon 33.5"- $170
Yukon 36.5"- $170
Yukon 39.5"- $180
Yukon 43.5"- $180
ECGS Rear Drive Flanges (Pair) - $250
American Double Splined 4340 Shafts (Pair) - $450
American Double Splined 300M Shafts (Each) - $425
Prices include Shipping

We also have the spindle boring tool available for purchase or rental

Spindle boring tool

--------------------------------------------------------------------------------

Boring Tool rental $125
Boring Service- $185
Boring Tool Purchase- $650
Replacment bits- $185


[attachment deleted by admin]

 

[BamaTJ]

That is cool. What is offerend in the way of semi-float 35 spline shafts. Not ready to buy any, just have never found many choices on them.

 

[bjeep]

We now have Rear flanges that will allow you to bore your spindle and run double spline dana 60,70,80 shafts. No front hub conversion necessary. Just bolt on the flange and give us your stock shaft measurement. We will have custom made 4340 or 300m shafts made for you. These shafts are made in america out of american stock with zero reported failures.

ECGS Rear Drive Flanges (Pair) - $250
American Double Splined 4340 Shafts (Pair) - $450
Prices include Shipping

Can you get the shafts splined for your hub on one end and for a sterling on the other?
What is the warranty on these?