hokie_yj
Well-Known Member
I've got a bunch of stuff I need to get out of the garage. Some of it are parts taken off my old buggy, and some are parts that I gathered for my new build that I'm not gonna use. I may have more stuff to add later. Everything is located in Surgoinsville, TN 37873. All prices are OBO.
RCI 2121a 12 gallon fuel cell. -8 pickup/return/vent, 0-90 ohm sender, no foam. Measures 18”x12”x12” Never had fuel in it, has a few minor scratches from being handled around the shop during mock up. $200 OBO + shipping
FSR 26”x19” triple pass radiator. Bought this to use in my build, but it ended up being too wide to fit where I needed it. It’s a really nice radiator, I’d keep it for future use but I need more parts for my build. It has three inlet fittings, a -16 male, a -12male, and a 3/8” npt female. It’s also has a 1/4” npt female port on top of the inlet tank that could be used as a vent. The outlet is for 1.25” hose, but Ihave a -16 male fitting I had planned to put on it that I’ll include. $350 OBO + shipping
Aluminum hawse fairlead. New, never used. Finish isn't perfect, but it's fully functional with no rough spots. Only selling because I need a narrow fairlead. $40 shipped, or trade for narrow aluminum fairlead.
Used propane parts from my old buggy. Was on a 4.3 V6. Impco 300A mixer hat, Model E evaporator, VFF30 vacuum lock-off. The lock-off valve is cracked because I tightened to outlet fitting too tight. I'm not sure if it's repairable or not. All this stuff should be considered needing rebuilt. $80 shipped for all of it.
MSD 6T ignition box. Was on the same 4.3 V6. I think it's good, but I can't guarantee it. $50 shipped.
RCI 2121a 12 gallon fuel cell. -8 pickup/return/vent, 0-90 ohm sender, no foam. Measures 18”x12”x12” Never had fuel in it, has a few minor scratches from being handled around the shop during mock up. $200 OBO + shipping
FSR 26”x19” triple pass radiator. Bought this to use in my build, but it ended up being too wide to fit where I needed it. It’s a really nice radiator, I’d keep it for future use but I need more parts for my build. It has three inlet fittings, a -16 male, a -12male, and a 3/8” npt female. It’s also has a 1/4” npt female port on top of the inlet tank that could be used as a vent. The outlet is for 1.25” hose, but Ihave a -16 male fitting I had planned to put on it that I’ll include. $350 OBO + shipping
Aluminum hawse fairlead. New, never used. Finish isn't perfect, but it's fully functional with no rough spots. Only selling because I need a narrow fairlead. $40 shipped, or trade for narrow aluminum fairlead.
Used propane parts from my old buggy. Was on a 4.3 V6. Impco 300A mixer hat, Model E evaporator, VFF30 vacuum lock-off. The lock-off valve is cracked because I tightened to outlet fitting too tight. I'm not sure if it's repairable or not. All this stuff should be considered needing rebuilt. $80 shipped for all of it.
MSD 6T ignition box. Was on the same 4.3 V6. I think it's good, but I can't guarantee it. $50 shipped.
