Indy Will
Well-Known Member
Got a ruff stuff 9" housing and Spidertrax Pro Series knuckles... sort of...
I wrecked with this housing and bent the inner C on the right. The one on the left i still almost brand new and good to go. The one on the right will need to be cut off and replaced.
This housing was also for a mid engine car where the diffs are run upside down. You can run it right side up (normally passenger side drop) by redrilling a couple holes and grinding out the notch for the ring gear though.
Set up for a 4 - Link.
When put together with unit bearings you'll see a WMS to WMS of about 65".
First $180 takes it. I'll ship if you want to pay for it. In Burlington, NC. 27215
Will at 336.693.4003
I wrecked with this housing and bent the inner C on the right. The one on the left i still almost brand new and good to go. The one on the right will need to be cut off and replaced.
This housing was also for a mid engine car where the diffs are run upside down. You can run it right side up (normally passenger side drop) by redrilling a couple holes and grinding out the notch for the ring gear though.
Set up for a 4 - Link.
When put together with unit bearings you'll see a WMS to WMS of about 65".
First $180 takes it. I'll ship if you want to pay for it. In Burlington, NC. 27215
Will at 336.693.4003
