Menu
Forums
New posts
Search forums
Calendar
Monthly
Weekly
Agenda
Archive
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Help Support Hardline Crawlers :
Forums
Rock Crawling Forums
Tech & Fab
The wifes runner
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="crash2" data-source="post: 1567402" data-attributes="member: 15940"><p>So the next part was a good challenge and I wanna say the last one I did was back in the day when NWOR was one of the only places to easily source parts.</p><p></p><p>So The caps on the joints had KC1720AD which I spent over an hour without being able to cross reference to anything via the web using the number on the cap.</p><p></p><p>Well I went with application and came up with this part number</p><p>Precision #513 and it is a perfect fit.</p><p></p><p>I had a hard time getting the caps out due to the body hitting not letting the cap work all the way out so I used the welder and a slide hammer. Ya the one joint was a little toast..</p><p></p><p>So one thing I can say is made certain the needle bearings where pin for the ball rides don't pop out of place--that was the one curve ball I ran into and broke a few of them. Since the ball was in perfect shape I just cut up one of the many CV's I had laying around and used the needle bearings.</p><p></p><p>Finally got that all done and installed.</p></blockquote><p></p>
[QUOTE="crash2, post: 1567402, member: 15940"] So the next part was a good challenge and I wanna say the last one I did was back in the day when NWOR was one of the only places to easily source parts. So The caps on the joints had KC1720AD which I spent over an hour without being able to cross reference to anything via the web using the number on the cap. Well I went with application and came up with this part number Precision #513 and it is a perfect fit. I had a hard time getting the caps out due to the body hitting not letting the cap work all the way out so I used the welder and a slide hammer. Ya the one joint was a little toast.. So one thing I can say is made certain the needle bearings where pin for the ball rides don't pop out of place--that was the one curve ball I ran into and broke a few of them. Since the ball was in perfect shape I just cut up one of the many CV's I had laying around and used the needle bearings. Finally got that all done and installed. [/QUOTE]
Insert quotes…
Verification
Post reply
Latest posts
2-2.5 ton Rockwell’s new in crates
Latest: Piros 1
Today at 2:47 PM
Off Road 4x4 Parts For Sale
Pluging holes
Latest: Piros 1
Today at 2:45 PM
General Discussion
Trail gear hydro assit on a toyota
Latest: baldduck74
Yesterday at 12:27 PM
General Discussion
For Sale
Suzuki Samurai Cleveland TN
Latest: jeeptj99
Yesterday at 8:52 AM
Vehicles For Sale
N
15x12 full offset beadlocks
Latest: Nathan08
Sunday at 4:59 AM
Wanted to Buy
Forums
Rock Crawling Forums
Tech & Fab
The wifes runner
Top