Neal3000
Well-Known Member
Need one out of a minitruck or 4runner, specifically all ineed is the t-case end of it
Sold/Expired Toyota non-cv driveshaft
- Thread starter Neal3000
- Start date
TBItoy
Well-Known Member
Re: Re: Toyota non-cv driveshaft
You need the slip yoke end or single ujoint fixed end? Pretty sure I've got a bunch of them
You need the slip yoke end or single ujoint fixed end? Pretty sure I've got a bunch of them
Neal3000
Well-Known Member
Re: Re: Toyota non-cv driveshaft
I just need the t-case side, single u-joint fixed end, i'm converting my front d-shaft to non-cv......could you cut one off and put it in a flat rate box?
TBItoy said:
I just need the t-case side, single u-joint fixed end, i'm converting my front d-shaft to non-cv......could you cut one off and put it in a flat rate box?
Neal3000
Well-Known Member
Also i've got one of them creeper joints to put in it so if you've got one with a ****ty u-joint i don't care
TBItoy
Well-Known Member
Re: Re: Toyota non-cv driveshaft
Actually... from the factory, the slip yoke is at the front (tcase) in the rear. That's where my confusion came from.
I'll get one for ya.
Neal3000 said:
Actually... from the factory, the slip yoke is at the front (tcase) in the rear. That's where my confusion came from.
I'll get one for ya.
