Menu
Forums
New posts
Search forums
Calendar
Monthly
Weekly
Agenda
Archive
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Help Support Hardline Crawlers :
Forums
Rock Crawling Forums
Tech & Fab
Tracker/dana 44 hybrid (turd polishing) build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Red97" data-source="post: 597533" data-attributes="member: 12467"><p>Thank you,</p><p></p><p>If I could have found some eb axles 44/9" I would have went that route. But got these 3 scout axles cheap. </p><p></p><p>The small bearing 9" is interchangeable with the tracker rear, so it may be possible to modify a mini spool and just swap shafts to fit a stock hoising.</p><p></p><p>I figure going this route would save me more money vs building the d44's or the toy axles I had.</p><p></p><p>The money I am saving from the gear/install kits will almost buy chromoly shafts if needed.</p><p></p><p>The toys were a little too narrow, would have had to run new spacers and buy wheels.</p><p></p><p>Figure since I have 4 tracker rears with 5.13 this was the best route to go.</p><p></p><p>I am planning a small top truss and a full backbone on the rear axle.</p><p></p><p>If anyone has good pic of a fabbed and trussed rear I would appreciate it.</p></blockquote><p></p>
[QUOTE="Red97, post: 597533, member: 12467"] Thank you, If I could have found some eb axles 44/9" I would have went that route. But got these 3 scout axles cheap. The small bearing 9" is interchangeable with the tracker rear, so it may be possible to modify a mini spool and just swap shafts to fit a stock hoising. I figure going this route would save me more money vs building the d44's or the toy axles I had. The money I am saving from the gear/install kits will almost buy chromoly shafts if needed. The toys were a little too narrow, would have had to run new spacers and buy wheels. Figure since I have 4 tracker rears with 5.13 this was the best route to go. I am planning a small top truss and a full backbone on the rear axle. If anyone has good pic of a fabbed and trussed rear I would appreciate it. [/QUOTE]
Insert quotes…
Verification
Post reply
Latest posts
I.w.i.w clampy
Latest: bobbedrunner99
Friday at 4:44 PM
Tech & Fab
Salvage 10
Latest: ridered3
Friday at 7:47 AM
Tech & Fab
Ultra4 - Battle in Bluegrass (Bowling Green, KY) East Series (4/19-4/20)
Latest: ridered3
Thursday at 12:01 PM
Trail Rides & Competitions
For Sale
2005 Ford Excursion Eddie Bauer
Latest: jeeptj99
Tuesday at 11:57 AM
Vehicles For Sale
For Sale
LS engine tube chassis buggy for sale
Latest: 99wranglersport
Apr 22, 2024
Vehicles For Sale
Forums
Rock Crawling Forums
Tech & Fab
Tracker/dana 44 hybrid (turd polishing) build
Top