Thank you, I built the chassis myself I wanted a cross between a WOD and Jimmy smith look, it has functioning doors 54'' wide.
Specs on the rig
4 tube 16'' King bypass shocks all the way around
2.0 king Coil carriers
9 inches up travel up front on the trailing arm I have around 24"
SCS case
TH400
LS stoker motor
Steering dana 80's with reid super kingpins the reason I went with 80's is I was able to get 2 47 spline spools for under 500 a piece and I got 2 dana 80's for 50 bucks locally. Then I ran a few numbers and realized I was able to run a drivers drop front and in the rear run the center section offset 2.125" while being able to use factory length rockwell inner shafts both front and rear. Whats cool about this is I had a company that makes a lot of mega truck and monster truck stuff make me 2 piece inners so its a double splined shaft and then a rockwell sized yoke that splines on like spidertrax. This way I have a spare yoke along with a spare short side and long side shaft which covers all of the inner shafts.