• Help Support Hardline Crawlers :

Recent content by YellowCJ

  1. Y

    Anti-wrap/traction bar options?

    This is what I did on my CJ... I think Lamar did the same type, you are supose to weld it, my is bolted on and ajustable.
  2. bambar6.jpg

    bambar6.jpg

  3. bambar5.jpg

    bambar5.jpg

  4. bambar4.jpg

    bambar4.jpg

  5. bambar2.jpg

    bambar2.jpg

  6. bambar1.jpg

    bambar1.jpg

  7. Y

    ZJ alarm

    I'm looking all over the place, found 1 that stated " pull the #6 and #7 fuse out of the passanger side kick plate", that it should dissable the alarm !?!? They also said dissconect the relay for the alarm that is under the glove box. There was another one that said to ground out the "purple...
  8. Y

    ZJ alarm

    Ok, I need to know how to dissconect the security system on a 95 ZJ, it has left my wife standing in a parking lot, with the little one, trying to open the door for over 30 minutes for the last time!!!! :mad: It's the type that you have to unlock the passanger door not to set it off, well now...
  9. Y

    New tires..TSL/SX's

    Look at Tyres International $235 each http://www.tyres1.com/ I don't know what shipping would be, but I have the advange of picking them up :D
  10. Y

    Nuzzy's The Apocalypse is Upon Us CJ Build...

    To bad your so far away, the Wife has me trowing CJ part out :booo:
  11. Y

    Spring Perches

    X 3 :hi:
  12. Y

    Lock-Rite in a AMC 20..

    Update... Got it all back together, ran it around the block and I'll damned, I think I blew the locker (sumofmabitch) so now after damn near a week doing what the Dr. said I shouldn't be doing I need to start all over and find out what the **** happened!! :mad: :wtf: (pass that bottle of...
  13. Y

    Lock-Rite in a AMC 20..

    I just got home from the garage, and yes, during the install of the locker the "blocker" in the center of the carrier wasn't replace. I thought about it for a while and went down, disasembled it and replaced it and come home to read your post. Why couldn't someone have told me this months ago...
  14. Y

    Lock-Rite in a AMC 20..

    The axle shifted inward, causing the "NEW" tire I just had mounted rub up against the clamp on the sping wearing a grove in the sidewall down to the treads!!
  15. Y

    Lock-Rite in a AMC 20..

    Has anyone had any issues with axles moving in-n-out eating bearings after installing a lock-rite in a 20 ??? (yea, yea, I know, I need to upgrade to D44's or something but this is what I got !!) This has caused me the loss of a 36" TLS in less than 2 miles :puke:

Latest posts

Top