Search results for query: *

I am in need of some good pull offs in 31 10.5 15 32 11.5 15 265 75 15 If you have some that would be streetable give me a shout. The closers to North Al. The better

I have a few parts for a Ford Dana 60 Spindles. $100 a pair Single wheel hubs with rotors. $200 Or all for $ 250 Needed them gone but no one bit so I'm not gonna give them away anymore I may have a pair of brake brackets also I will through in Arab Al.

I need two, one left one right 3/4 inch weld in bungs for 3/4 rod ends

I have two mixers one ride since rebuild on both. Two evaporaters one ride since rebuild on both. Two new in the box electric lock-off valves and 5 aluminum tanks 2 are full. Brackets fittings and hoses. Base plates and adapters. Even a small one wire distributor that clears the mixer. I can let...

I was looking for a shifter cable for a turbo 400

I need a transmission for a 2000 F250 superduty with a 7.3 power stroke in North Alabama

I know it has been discussed before but I can't find the thread. How do you figure volume of a double ended cylinder, and such orbital do I need for it? My ram is 2 inch with 1.25 shaft with 8 inches of travel.

Got a pair of Ford 60 brake brackets make offer get pictures later . Baileyton Al.

I built this with parts I had. It started life as a 68 power wagon w300 front axle. I cut the closed knuckle off and had Dana 60 tubes with Cs on them turned down to fit inside the huge 3.5 inch axle tubes of the 70. Then slid them inside for a double tubed axle and welded around the end. This...

I have a pair of ford 78-79 60 spindles take $100 in Arab Al.

I am looking for wide 14 bolts 70 plus inches wms to wms. Go!

I have a stock serpentine belt bracket set with water pump and alternator. Power steering pump and pulley does not come with it $ 100 north Al. Also come with air conditioning delete pulley

I have one xp new only used for mock up in north Al. $ 225 losing money bad but gotta go

Looking for at least 1 33 12.5 15 mudders for spares or maybe a full set if cheap enough I'm in north Alabama

I am needing the side gears, the ones the axle slides into, part of the spider gears for an open carrier Dana 60 35 spline

Wanted coil over springs 14 16 and 18 inch lengths all different weights for 2 inch coil overs

Need a stock turbo 400 to 205 figure 8 pattern adapter in north Alabama

Want to trade cucv 60 and 14 bolt for rockwells in Arab Al.

I have 2 Dana 70 4.56 ring and pinions one is new $150 one is used $100 in perect shape. In Arab Al.

Im in need of an open 1 piece carrier 4.56 and up for a dana 70 HD cheap