Search results for query: *

I am to the point where I am looking for knuckles for my 9/10" Frontend. I know I want to run 40 spline shafts, I have not decided on which axles yet as I would love to have 50 degree steering but that means u joints not Rcv's. I have been considering 3 knuckles but none are exactly what I want...

I am building a set of spidertrax 9's with there ultimate knuckles and unit bearing. My question is if there is a draw back to making the WMS of the housing wider and using a wheel with more back spacing as compared to a shorter wms with a less offset wheel? For example would it be ok? Better...

Does anyone know of a company that I could send a custom aluminum fuel cell to get hard anodized? Closer to Ohio the better. I tryed googling it but all the places I found only do commercial work not one part or tank. Thanks

Putting a 4 stage dry sump on the Ls in my bouncer, question is, can you mount the oil tank in the rear of the buggy? Running out of room quickly in the engine compartment. Is that too far away from the pump for it to work properly? Are there any supposed rules to where it must be mounted? I...

Does anyone know which rotor, caliper etc to use on a front and rear spidertrax 9" with pro knuckles and unit bearings to be able to run a 15" wheel with positive backs spacing?

What are you guys that are running Ls fuel injected motors that are basically running open fender well headers doing about the O2 sensors? I have been reading that open headers will burn up the O2 sensors?

I am putting together a small rock bouncer style buggy, I am trying to keep the drivetrain as short as possible which leads to the C4/Atlas combo. Issue number one.. Has anyone mounted a C4 to an Ls? I have tried researching but havnt found much info, I know a Jw ultra bell housing for a C4 to...

Looking to buy a shorty powerglide for a buggy build, will be going behind a 500 HP small block with 38" tires and weighing around 3,000lbs. Maybe a little more. I was looking at Hughes transmissions but I don't know which one is "enough". I know everything is able to break, I don't want to...

Currently trying to plan a new mini bouncer build and I am debating on using a TH350 or Shortie powerglide. Does anyone have the over all lengths of either of those transmissions coupled to an Atlas 2? Trying to keep drivetrain length as short as possible.