Search results for query: *

Does anyone in Oregon or Washington re center hummv wheels.

I bought this gear set used; they said they were for a CJ Jeep. After trying to set up gear to get a good pattern, I am not so sure. It is an AMC 20 in a 76 CJ narrow track. I need help Identifying the gear manufacturer so I can run the numbers.

I have a Dana 30 carrier. How do I tell if it

Well it might be new some of you. A friend told me about this, I had never heard of this but it worked. If you don't have a bearing race pull just put two one inch or so welds on it one on the top and on the bottom. Just make sure you don't weld the race to what ever you are pulling it out of...

weld a trac loc? Has any one ever welded a trac loc? did it last? Did it have any other problems?

I have a trac loc in may Amc 20 rear end. I want to repack the clutches in it but I can't find in info on this. Can anyone help?

http://www.youtube.com/watch?v=RqmlOAlxhE8 http://www.youtube.com/watch?v=8i_2giyvTO4

Kids are good for some thing! http://www.youtube.com/watch?v=8i_2giyvTO4

The defrost in my 1976 CJ 5 jeep, just doesn’t cut it. Anyone have any help, Such as upgrades or tricks that will help. It really sucks when you can see.

Here is some pic of my rock slider I made. I started by making cardboard template to see how it would look, you can see I make some changes. I used 2x4 square tube 1/4 thick and 3/16 plate. They also double as air tanks. I had them sprayed with Vortex spray on liner Heller Bro. custom spray...

This is my first gear setup. Is this pattern ok? Do I need to keep working on it. Hope the photo attached. I know dang newbies.

I have a TH400 trans from a 76 wag, it has a 10 spline shaft in it. Can I change it to a 32 spline shaft from another TH400 from GM? Thanks for all the in put! I am putting a dana 20 t-case behind it. which of the three shafts ( short or long) would I need? Who make the best trans to t-case...

I have a jeep that I am putting a Dana 44 front axle from a chevy under it . what part do I need to put a ford rotor on the spindle out, this way I don't have to change wheels.