Search results for query: *

i am replacing a ps pump on a 96 grand cherokee for a friend and on her original pump was a steering evo sensor got it out. Now my problem is with the reman pump i cannot get the line bolt out to install the evo sensor, My question is does it need the evo sensor to work properly. never ran into...

i might be up in a blue toota truggy and another toyota

its old but it runs good its an airco 160 dipstick, hooked it up today took a min to figure out the amp/volt settings to run smooth but it ran a good pass.:beer:

which trail leads you to the crack next time i go there i want to check it out see if my friends rigs can make it.

well i started this a while ago and then ran out of money but not before i got my d60 front and a 14bolt for the rear along with my eng trans and t case. it started out sprung over done by me then i pulled the eng and trans out sold most of the stock stuff, stuffed my front 60 in with leaf...

i found this steering orbital and was wondering if it would work the prce is kinda catchy https://www.surpluscenter.com/item.asp?UID=2009102106491544&item=9-7666&catname=hydraulic

i was wondering if some one could give me some advice on narrowing my d60, i need to shorting the passenger side i am thinkin of cutting the c off then porto-banding the axle tube to the desired length then re welding. also wrapping it with something to let in abient cool, just need some...

after installing my spool in the drop out and double checking everything to make sure it was right before i installed it, which everything was, but while installing my shafts i rotated them as if i was reversing and it sounds like the ring gear is contacting the housing, or so i think but it...

so i decided that i would pull my third on my 9inch axle today and to my suprise i cracked my lsd last weekend at reiter all the way around the bolts to my ring gear, luckily for me i have had a spool sitting there on my work bench since march, now to my question since its been so long since ive...

im thinkin of doing a disk conversion on my 9inch and was wondering if anyone knows which rotor would work best