Search results for query: *

HA! He barely knew how to use the gas pedal yesterday. Need to fix my junk then we will get back out so he can get some practice in it.

Nice to meet you yesterday. Once Aaron learns to drive he's going to have tons of fun with it. Looking forward to that AOP ride once your new rig is ready.

I got some woodward fab one to start with because it was cheap. It didn't last long. Been using my Versa notcher for a few years now with no issue.

X2 on it's cheap. It works but it's cheap.

What pan is it? I always had trouble getting stock pans to seal.

Thanks for posting! I’ve been wanting to get a XJ and go racing too. Nice to see some tech on it. Sent from my iPhone using Tapatalk

I run my winch power lead to the starter terminal. Just use adequate wire, I use some large welding lead cable/wire I got off of amazon. I don’t remember the gauge right off hand though. I’ve also wired up a friend’s the same with no issues. So I don’t see what you’ve got in mind being an...

I've been using Sidney Lee, I bought a mix bottle and an argon bottle. They are about $30-35 to exchange each. I do believe they were around the $300 to buy them 6 years ago or so. Sent from my iPhone using Tapatalk

I think you can get on the gotpropane website and he has a simple instruction manual on how to tune. Like others said there's basically one screw you turn on the mixer. Sent from my iPhone using Tapatalk

What part of Atlanta? I'm in Stockbridge/McDonough area. Sent from my iPhone using Tapatalk

Pretty sure I used some dull cheap bit laying around. I don't remember having any trouble at all. Sent from my iPhone using Tapatalk

That's all I have in my phone I think. I like it makes it a lot easier in my opinion. Sent from my iPhone using Tapatalk

I've got it. It's well.... It's okay as a reference but I wouldn't use it for precise measurements. I've got mine set up to bend vertical and I use a digital level. Sent from my iPhone using Tapatalk

I have mine mounting similar on my SBC. I think the theory is directly above helps eliminate starvation or whatever. As long as you can route the feed line to the pump with no issues I'd rock it. And maybe think about some protection for the resi. Mine sticks up similar and I knocked off...

Re: Can i use dodge d60 axles in chevy d60 The long side inners are the same. The dodge short side is shorter. Outers are the same. Sent from my iPhone using Tapatalk

Think I found mine from Denny's driveline. Sent from my iPhone using Tapatalk

I used nutserts. They were easy and give a clean look. But I've pulled several out when removing panels. I personally don't think I'd use them again so scratch that off your list. Sent from my iPhone using Tapatalk

I don't remember off hand. I'll check when I get home this afternoon.

I have a similar Derale trans cooler, it was pricey and small. Didn't do to well of a job in my opinion. I replaced it with this piece from summit. It's MUCH larger and cheaper. https://www.summitracing.com/parts/hda-526/overview/

Yeah we just a buddy of mines 4.3 running on a used propane setup. After finding the massive unplugged hole in the manifold, oops, it would start and run. But it was extremely rich. I talked him into calling Buddy over at Alt fuel I think it is, he is on here, and Buddy told him the exact...