Menu
Forums
New posts
Search forums
Calendar
Monthly
Weekly
Agenda
Archive
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Help Support Hardline Crawlers :
Forums
Rock Crawling Forums
Tech & Fab
1350 carrier bearing setup
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Hudson1" data-source="post: 745115" data-attributes="member: 5184"><p>I also built mine. I had Hudlow Axle in Chattanooga build me a short 32 spline shaft, then did the same with a set of yokes and some DOM on my lathe. </p><p> Sealed roller bearings aren't the best for the side loads, but have held up well to my abuse. Tapered wheel bearings would be the best, but would need the ends of the shaft threaded for a nut and washer and the DOM machined for the race. </p><p></p><p>I used roller bearing , then drilled and tapped the end of the shaft. The bearings are a press fit onto the Yokes then are retained onto the shaft with bolts.</p></blockquote><p></p>
[QUOTE="Hudson1, post: 745115, member: 5184"] I also built mine. I had Hudlow Axle in Chattanooga build me a short 32 spline shaft, then did the same with a set of yokes and some DOM on my lathe. Sealed roller bearings aren’t the best for the side loads, but have held up well to my abuse. Tapered wheel bearings would be the best, but would need the ends of the shaft threaded for a nut and washer and the DOM machined for the race. I used roller bearing , then drilled and tapped the end of the shaft. The bearings are a press fit onto the Yokes then are retained onto the shaft with bolts. [/QUOTE]
Insert quotes…
Verification
Post reply
Latest posts
I am moving to Tennessee
Latest: Kubotaorange76
Yesterday at 8:48 AM
General Discussion
For Sale
2005 Ford Excursion Eddie Bauer
Latest: jeeptj99
Monday at 11:55 AM
Vehicles For Sale
I.w.i.w clampy
Latest: bobbedrunner99
Friday at 4:44 PM
Tech & Fab
Salvage 10
Latest: ridered3
Friday at 7:47 AM
Tech & Fab
Ultra4 - Battle in Bluegrass (Bowling Green, KY) East Series (4/19-4/20)
Latest: ridered3
Thursday at 12:01 PM
Trail Rides & Competitions
Forums
Rock Crawling Forums
Tech & Fab
1350 carrier bearing setup
Top