2" J2 die

Barefoot_Offroad1 · Oct 20, 2015

Does anyone have a 2" die for the J2 bender? I need to bender up a lower link about 20 degrees and do not want to spend $400 on a die I will use once. I have A/H Model 32 - J2 bender

Only need it for about 30 min.

Zoediak · Oct 20, 2015

Barefoot_Offroad said:
Does anyone have a 2" die for the J2 bender? I need to bender up a lower link about 20 degrees and do not want to spend $400 on a die I will use once. I have A/H Model 32 - J2 bender

Only need it for about 30 min.

I will have to double check mine, but I have the model 32 and if memory serves right, I should have the 2" 6.5 180* die set...

it is packed away in storage at the moment, but I can look when I get off work this afternoon.

I am a bit far south though in Graham (about 15 miles south of Puyallup)

Barefoot_Offroad1 · Oct 20, 2015

Let me know and if you want to sale it, it would save me a ton of time and driving.

Zoediak · Oct 20, 2015

yup.. just confirmed... what I listed above is what I have...

if you want to borrow it, sadly I am not closer, hit me up.

cell# 253-227-0ne zero 4 zero

Barefoot_Offroad1 · Oct 29, 2015

Zoediak said:
yup.. just confirmed... what I listed above is what I have...

if you want to borrow it, sadly I am not closer, hit me up.

cell# 253-227-0e zero 4 zero

Thanks for your help, I will get the job done and get it back to you. Man it was a PIA putting on the bender, did not realize how heave that much steel weighs