Menu
Forums
New posts
Search forums
Calendar
Monthly
Weekly
Agenda
Archive
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Help Support Hardline Crawlers :
Forums
Rock Crawling Forums
Tech & Fab
All he ramp builders out there.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="skipnrocks" data-source="post: 696293" data-attributes="member: 3166"><p>Sorry probably didnt describe that well enough. I will have 18 angle iron cross members that will run the full width of the trailer. I will have four main bars (2x6x8ft) two for each ramp. But I want to tie the four runners together with some tubing for structural support since the ramps will actually form the last 8 ft of the bed. I will have one that goes all the way across that the hydraulic rams attach too for lifting it up and down, and then an additional three for support. </p><p></p><p>I will definitly be cutting a taper into mine at the bottom to make it easy for a car to drive onto, and into the top to allow it to pivot without hitting the trailer.</p></blockquote><p></p>
[QUOTE="skipnrocks, post: 696293, member: 3166"] Sorry probably didnt describe that well enough. I will have 18 angle iron cross members that will run the full width of the trailer. I will have four main bars (2x6x8ft) two for each ramp. But I want to tie the four runners together with some tubing for structural support since the ramps will actually form the last 8 ft of the bed. I will have one that goes all the way across that the hydraulic rams attach too for lifting it up and down, and then an additional three for support. I will definitly be cutting a taper into mine at the bottom to make it easy for a car to drive onto, and into the top to allow it to pivot without hitting the trailer. [/QUOTE]
Insert quotes…
Verification
Post reply
Latest posts
I.w.i.w clampy
Latest: bobbedrunner99
Friday at 4:44 PM
Tech & Fab
Salvage 10
Latest: ridered3
Friday at 7:47 AM
Tech & Fab
Ultra4 - Battle in Bluegrass (Bowling Green, KY) East Series (4/19-4/20)
Latest: ridered3
Thursday at 12:01 PM
Trail Rides & Competitions
For Sale
2005 Ford Excursion Eddie Bauer
Latest: jeeptj99
Tuesday at 11:57 AM
Vehicles For Sale
For Sale
LS engine tube chassis buggy for sale
Latest: 99wranglersport
Apr 22, 2024
Vehicles For Sale
Forums
Rock Crawling Forums
Tech & Fab
All he ramp builders out there.
Top