Mortalis5509
Well-Known Member
I am posting up my Jeep that I recently built, but it's not being sold as complete like the pictures show it. Everything is months old except the trans and motor.
Reasone for Sale: I'm getting into racing more and reusing some of the parts that I had on there for the race car.
Built 5.3 - cam, rod bolts, push rods, timing chain, tuned, spare alternator, spare water pump, spare thrmostat, psi harness, 3qt oil accumlator, low profile pan
TH350 - needs to be rebuilt, RMVB, TCI 2400 torque convetor that matches the cam and pulls hard, winters shifter, coolers
Corbeau seats
Atlas 4 speed 1410 yokes
Front and rear Tom woods drive shafts that have 1410 joints
Front and rear 4 link with Ruffstuff 1.25" joints that put wheelbase at 113"
12 volt switch - Push start, power switch, hardwire for winch, interior lights, reverse lights, head lights, light bar, 2 different switches for seat heaters, 2 acc switches, 2 cig lighter with constant power, rock lights, master kill switch
RCI 15 gallon cell
Full roll cage tied into the frame with the seats on it, 1 3/4" all DOM
Custome built frame
Front and rear antirock
Set up for coilovers and bump cans welded in
Guages - tach (never got it to work with the 5.3), fuel, engine temp, trans temp (pan tapped), volts, and oil pressure
Polyethelyne skid plates that cover the oil pan with an entire spare set
Removeable rear tire carrier or CJ tail gate. Both cannot be ran at the same time
What it needs: Steering, axles, tires, wheels, harnesses, winch
$16,000
Reasone for Sale: I'm getting into racing more and reusing some of the parts that I had on there for the race car.
Built 5.3 - cam, rod bolts, push rods, timing chain, tuned, spare alternator, spare water pump, spare thrmostat, psi harness, 3qt oil accumlator, low profile pan
TH350 - needs to be rebuilt, RMVB, TCI 2400 torque convetor that matches the cam and pulls hard, winters shifter, coolers
Corbeau seats
Atlas 4 speed 1410 yokes
Front and rear Tom woods drive shafts that have 1410 joints
Front and rear 4 link with Ruffstuff 1.25" joints that put wheelbase at 113"
12 volt switch - Push start, power switch, hardwire for winch, interior lights, reverse lights, head lights, light bar, 2 different switches for seat heaters, 2 acc switches, 2 cig lighter with constant power, rock lights, master kill switch
RCI 15 gallon cell
Full roll cage tied into the frame with the seats on it, 1 3/4" all DOM
Custome built frame
Front and rear antirock
Set up for coilovers and bump cans welded in
Guages - tach (never got it to work with the 5.3), fuel, engine temp, trans temp (pan tapped), volts, and oil pressure
Polyethelyne skid plates that cover the oil pan with an entire spare set
Removeable rear tire carrier or CJ tail gate. Both cannot be ran at the same time
What it needs: Steering, axles, tires, wheels, harnesses, winch
$16,000
