Menu
Forums
New posts
Search forums
Calendar
Monthly
Weekly
Agenda
Archive
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Help Support Hardline Crawlers :
Forums
Rock Crawling Forums
Tech & Fab
blown sbc?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="kmcminn" data-source="post: 119664" data-attributes="member: 982"><p>I have used birmingham driveline i think that is the name. Neapco makes the components I used. I would buy to female parts and one male and make two driveshafts, the male piece is 24 inches long I think. The female ends used to be about 40 a piece and i am wanting to say the male piece was right under 200 dollars. I always use a thick wall tubing for actual driveshaft. get the stock slip yoke put it in lathe bore it out, and turn down the male long splined piece to go in the old slip yoke part and then weld them up. Weld the female part into the thick wall tubing and the old end of your driveshaft and make other end to length that you need. If you didnt have a shop to do it I would tell you to get it to me and I would do it for you.</p></blockquote><p></p>
[QUOTE="kmcminn, post: 119664, member: 982"] I have used birmingham driveline i think that is the name. Neapco makes the components I used. I would buy to female parts and one male and make two driveshafts, the male piece is 24 inches long I think. The female ends used to be about 40 a piece and i am wanting to say the male piece was right under 200 dollars. I always use a thick wall tubing for actual driveshaft. get the stock slip yoke put it in lathe bore it out, and turn down the male long splined piece to go in the old slip yoke part and then weld them up. Weld the female part into the thick wall tubing and the old end of your driveshaft and make other end to length that you need. If you didnt have a shop to do it I would tell you to get it to me and I would do it for you. [/QUOTE]
Insert quotes…
Verification
Post reply
Latest posts
P
Official "Post your trail riding pics" Thread
Latest: paradisepwoffrd
Today at 9:49 AM
General Discussion
Golden Mountain Off-road Park opening
Latest: 1tonrenegade
Today at 9:38 AM
General Discussion
Coalmont TN OHV New Park info
Latest: jeeptj99
Today at 8:55 AM
General Discussion
Hollar wood offroad park next weekend
Latest: baldduck74
Yesterday at 4:22 PM
General Discussion
Cash LeCroy Illness
Latest: ridered3
Yesterday at 1:02 PM
General Discussion
Forums
Rock Crawling Forums
Tech & Fab
blown sbc?
Top