Ok so this prolly has been covered be for . Looking for advise,suggestions or thoughts.
I'm setting up the bump cans.looking for info for how much space between the bump and pad.
Chassis is a rock bouncer
20" ori struts they have around 7-8" of compression
4" travel bumps
Rite now I have it mocked up with 2" spacing between bumps and pads
Thanks for any info
new to the Ori's setup ,oris have internal bumps I figure that I'd setup the cans for around 6" of comp.and that'd let the ori's have an inch to keep them from every from bottoming out
I no ori says you don't have to run bumps ,but ori clearly states you dont wanna bottom them out.
I'm setting up the bump cans.looking for info for how much space between the bump and pad.
Chassis is a rock bouncer
20" ori struts they have around 7-8" of compression
4" travel bumps
Rite now I have it mocked up with 2" spacing between bumps and pads
Thanks for any info
new to the Ori's setup ,oris have internal bumps I figure that I'd setup the cans for around 6" of comp.and that'd let the ori's have an inch to keep them from every from bottoming out
I no ori says you don't have to run bumps ,but ori clearly states you dont wanna bottom them out.
Last edited: