Cut And Re-spline

DiRtY Bill · Jan 28, 2008

Does anybody know of a machine shop in central Washington (Yakima) that can cut and re-spline a D44 shaft? i have found a few places out of state like Curry, but then i have to pay freight both ways. any help would be appreciated.

kegwilliams · Jan 28, 2008

spline'n

I send mine to duchmans in Portland, they did a great job on a 60 axle

heep70 · Jan 28, 2008

As said above "Dutchman" :awesomework:

http://www.dutchmanms.com/index.html

superglock · Jan 28, 2008

Bitemedoughboy.com if you want give me a call, Mike 697-4178. I have a few questions.

JPTHING · Jan 31, 2008

I had Jesse at Olympic 4x4 get mine splined. it was $75.00 for both sides. Mine were 1-5/8" D60-35 spline blanks splined to 14b-30 spline.

boxboy · Jan 31, 2008

Carl Jantz http://www.jantz4x4.com/contact.php

DiRtY Bill · Jan 31, 2008

thanks for all the help guys.... but anything on the east side of the cascade mtn's???

Cascade_Crawler · Jan 31, 2008

boxboy said:
Carl Jantz http://www.jantz4x4.com/contact.php

this is who I used, 1 day turnaround :awesomework:

Little Red Zuk · Jan 31, 2008

Anybody I know on the eastside of the mts would send them to one of the above places anyway.

benw1 · Jan 31, 2008

How soon are you looking to get them done? I have all the tooling to do them, and I have done splining in the past, but I have a fair amount of work I need to do to get set up to do it. My schedule is extremely tight right now so it would be a couple months before I could get to it.