crawler1
Well-Known Member
I am running a high pinion rear Dana 60 with 35 spine axles and a ford 9 inch setup up on the out side for bearings . I keep exploding the mossier bearings every time i go wheeling . I am wanting to try to convert it to a full floater rear end . I just purchased a dana 60 rear semi floater and i am planing on cutting it up and using the outer axle tube spindles and weld them on to my rear high pinion 60 to make it a full floater . i also have purchased a set of 6 lug dana 60 hubs hopping to try to put them on the rear to make it a full floater . My question is this all going to be possible to convert ,or should i just build a new rear end and scrap the idea . My main problem is were do i get full floater 35 spline axles made . I have heard that Adam Woodlee is the man to talk to on this . I have heard he has done this a time or two . Any help or comments would be greatly appreciated on this ..