Dana 60 knuckle rebuilt

[bobracing]

Anybody know were to get a tool for removing the upper "king pin"?
I used a piece of 7/8 stainless steel hex but just twisted the SS.

 

[crash2]

YOu mean the big tappered steel piece? I never remove them unless you are upgrading to a tappered bearing setup/tossing the nylon cone...

 

[bobracing]

Yes, the tappered piece. I was informed that these wear, not sure how against teflon, but also not really interested in tearing it apart again. Might just take the chance and just replacing everything else.

Thanks for the response

 

[Six-Nine]

I got the 7/8 hex for mine at Tacoma screw...

 

[Binder]

Don't take it out unless it's broken. If it's broken you could weld something to it as a lever.