Drive Slugs

Jeepasaurusrex · Oct 6, 2016

I'm running a Warn Full Float on an AMC 20 rear. A couple of weekends ago, I blew a rear hub over at Naches. I have heard that Dana 44 drive slugs will fit. Anyone have one or a pair laying around that I can try? :redneck:

TreeClimber · Oct 6, 2016

Warn shafts are 30 spline.

Typical OEM drive shafts were either course spline (think 19) or fine spline at 27.

Warn makes a 30 spline drive slug, as do many aftermarket vendors. I don't recall any factory (OEM) applications where they used 30 spline drive slugs.

Been a while since I played with Dana 44 stuff, so I may be wrong, but this is how I remember stuff.

JOOP · Oct 6, 2016

I think I have some 19 spline laying around. I'll have to do some digging.

Jeepasaurusrex · Oct 7, 2016

I am pretty sure mine are 30 spline axles.

I found this article on converting from locking hubs to drive slugs.

http://www.cj-8.com/content.php?42-Spankrjs-1984-Long-Term-Project