Menu
Forums
New posts
Search forums
Calendar
Monthly
Weekly
Agenda
Archive
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Help Support Hardline Crawlers :
Forums
Rock Crawling Forums
Tech & Fab
Finally....Da new rig..
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="crash2" data-source="post: 1566429" data-attributes="member: 15940"><p>So my original intention was to make supports of the motor mounts and make the skid/mounts one who assembly and then add holes to access the drain plug. Well this is where I found the motor mounts sit on top of the chassis rails and the rear shock mounts kinda go over top the mounts so if it was one whole assembly there would be no way to remove it. So it required more thinking to figure that out. So I ended up making stand offs and adding a little more support to the skid to help keep it from being able to be shoved to one side. The stand offs need to be fully welded and the back part of the skid mount made under the tranny pan but that will be done once I get the motor/trans pulled out of the rig.</p></blockquote><p></p>
[QUOTE="crash2, post: 1566429, member: 15940"] So my original intention was to make supports of the motor mounts and make the skid/mounts one who assembly and then add holes to access the drain plug. Well this is where I found the motor mounts sit on top of the chassis rails and the rear shock mounts kinda go over top the mounts so if it was one whole assembly there would be no way to remove it. So it required more thinking to figure that out. So I ended up making stand offs and adding a little more support to the skid to help keep it from being able to be shoved to one side. The stand offs need to be fully welded and the back part of the skid mount made under the tranny pan but that will be done once I get the motor/trans pulled out of the rig. [/QUOTE]
Insert quotes…
Verification
Post reply
Latest posts
D
MMORV - SETTC - September 27-29,2013
Latest: Dammit Tammy Lets Ride
52 minutes ago
Trail Rides & Competitions
B
For Sale
98' XJ, absolute unit, $17,500
Latest: BigO66
Today at 3:37 PM
Vehicles For Sale
2-2.5 ton Rockwell’s new in crates
Latest: Piros 1
Saturday at 2:42 AM
Off Road 4x4 Parts For Sale
For Sale
Jeep TJ tube buggy for sale $32,000.00
Latest: Piros 1
Saturday at 2:41 AM
Vehicles For Sale
T
For Sale
85-91 Ford Kingpin Dana 60 $2k
Latest: truck-oholic
Friday at 3:58 PM
Off Road 4x4 Parts For Sale
Forums
Rock Crawling Forums
Tech & Fab
Finally....Da new rig..
Top