Posting for a friend.
Contact me and I'll pass along info. He's wanting to sell these ASAP to get his house started.
$2200 Firm for the pair. Or....
$1600 for the front
$700 for the rear
No trades thanks.
I have a set of axles out of my rock crawler that have not been run in a couple of years.
The front is a Ford driver side drop, high pinion, king pin dana 60 with high steer arms, a 3/4 heim dom tie rod, stock shafts, warn lockout hubs, 5.13 gears and a detroit locker. It has dual piston calipers that have been shaved down to fit in 15" beadlocks. Tubes shaved clean. Brakes are good. Could probably use wheel bearings cause they weren't cleaned after last used.
The rear is a Sterling 10.25 full floater with the same setup. Has 5.13 gears and a detroit locker. 35 spline 1.5" axle shafts. Spring perches and everything have been shaved off. Brakes are good, drums are off in the pics but I have them and they're in good shape.
They have both been sitting in my shop for a couple years because I was saving them for a future project but I'm not planning on using them anymore.
Contact me and I'll pass along info. He's wanting to sell these ASAP to get his house started.
$2200 Firm for the pair. Or....
$1600 for the front
$700 for the rear
No trades thanks.
I have a set of axles out of my rock crawler that have not been run in a couple of years.
The front is a Ford driver side drop, high pinion, king pin dana 60 with high steer arms, a 3/4 heim dom tie rod, stock shafts, warn lockout hubs, 5.13 gears and a detroit locker. It has dual piston calipers that have been shaved down to fit in 15" beadlocks. Tubes shaved clean. Brakes are good. Could probably use wheel bearings cause they weren't cleaned after last used.
The rear is a Sterling 10.25 full floater with the same setup. Has 5.13 gears and a detroit locker. 35 spline 1.5" axle shafts. Spring perches and everything have been shaved off. Brakes are good, drums are off in the pics but I have them and they're in good shape.
They have both been sitting in my shop for a couple years because I was saving them for a future project but I'm not planning on using them anymore.
