Sold/Expired Ford NP435 to Dana 300 for Jeep 4.0L - SOLD SOLD SOLD -

redmanyj · Aug 6, 2012

i've got a ford np435 with the AA adapter for a dana 300. The transmission was rebuilt and a new 1st gear and reverse idler gear were installed to eliminate the 1st gear pop out. It has a 6.68:1 granny gear. It also has the bellhousing to bolt up to a jeep 4.0L. The bell housing has the crankshaft position sensor installed. Comes with the shifter. Asking $600. I can get a stock dana 300 to add to the tranny for an extra $300. Looking for Atlas, stak, doubler, nv4500. Located in Marietta, GA. Ship on your dime.

redmanyj · Aug 7, 2012

Re: Ford NP435 to Dana 300 for Jeep 4.0L

bump

redmanyj · Aug 9, 2012

Re: Ford NP435 to Dana 300 for Jeep 4.0L

bump

broncomike · Aug 9, 2012

Re: Ford NP435 to Dana 300 for Jeep 4.0L

How long is it from frontof bell to back of adapter? And what clutch slave does it use?

redmanyj · Aug 10, 2012

Re: Ford NP435 to Dana 300 for Jeep 4.0L

clutch is whatever you have bolted to your motor. It uses a slave from an 80's cj with a longer push rod. I can throw in the slave if needed. I will measure length this afternoon.