pholmann
Well-Known Member
1993 ford ranger rock crawler with a good title. It's been a damn good rig but it needs some tlc. This thing has been all over the place and flat out works. It's geared very well. Runs strong and needs little mechanically. Call or text 865-582-1283. Located in Knoxville tn
The bad- the link mounts at the frame need redone. They've been bent, straightened, welded, braced, and bent again. All 4 lower mounts at the frame will need redone. That's not a big deal. It's having a cooling issue. It may need head gaskets. I've been having troubles for a bit keeping the cooling system bled out. Once it's bled it's good for the day until the next time it sits 2 weeks.
The good-15-42-15 tsl swampers on 15x10 allied 32 bolt beadlocks tires about 30% uncut and none have been patched or vulcanized
-04' Dana 60 front welded and hubs re-drilled to 8x6.5" pattern
-74' Dana 60 rear welded
-5.13 gears
-88' ford 302 truck motor efi
-Np435 4 speed bulldog trans mated to an np205 with twin sticks
-4 link rear
-Y link front with pan hard bar
-Lowers are 7/8" chromoly heims with .330 wall Dom links sleeved with schedule 80
-Uppers are 3/4 heims with Threaded dom
-12,000lb badlands winch in front
-Rear axle control winch and limiting straps
-Coil spring front
-Full hydro steering with two ended 2.5" ram
-Trail gear orbital valve
-Rear radiator
-1350 unjointed in rear driveline
-Bed is pinched and bobbed and the tailgate still works
-Am/fm CD player
-Ac still works
-Fabricated front winch bumper
-12 gallon rci fuel cell in the bed
-Flowmaster exhaust
117" wheelbase
The bad- the link mounts at the frame need redone. They've been bent, straightened, welded, braced, and bent again. All 4 lower mounts at the frame will need redone. That's not a big deal. It's having a cooling issue. It may need head gaskets. I've been having troubles for a bit keeping the cooling system bled out. Once it's bled it's good for the day until the next time it sits 2 weeks.
The good-15-42-15 tsl swampers on 15x10 allied 32 bolt beadlocks tires about 30% uncut and none have been patched or vulcanized
-04' Dana 60 front welded and hubs re-drilled to 8x6.5" pattern
-74' Dana 60 rear welded
-5.13 gears
-88' ford 302 truck motor efi
-Np435 4 speed bulldog trans mated to an np205 with twin sticks
-4 link rear
-Y link front with pan hard bar
-Lowers are 7/8" chromoly heims with .330 wall Dom links sleeved with schedule 80
-Uppers are 3/4 heims with Threaded dom
-12,000lb badlands winch in front
-Rear axle control winch and limiting straps
-Coil spring front
-Full hydro steering with two ended 2.5" ram
-Trail gear orbital valve
-Rear radiator
-1350 unjointed in rear driveline
-Bed is pinched and bobbed and the tailgate still works
-Am/fm CD player
-Ac still works
-Fabricated front winch bumper
-12 gallon rci fuel cell in the bed
-Flowmaster exhaust
117" wheelbase