jmh78
Well-Known Member
RockCrusher HP60R rear end with Jana76, Load Bolt, Stud Girdle Cover.
Full Float with HP70R 5:13 gear, PowerLock with extra clutches to make it like a spool. Carl Jantz installed the 70 gear set, the ring gear load bolt and the girdle cover.
Axle has not been ran since Jana76 upgrade.
-Approx. 64" WMS
-3/4 ton disk brakes
-Full float
-Yukon forged yoke
-Double splined chromoly shafts
-RockCrusher drive flanges
-New rotors and calipers
-New Solid Axle wheel hubs 8 lug pattern
or
-Used RockCrusher wheel hubs drilled for both 6 lug patter and 8 lug pattern
-Set up for fourlink, coilovers and air bumps
$2800 with new wheels hubs or $2500 with used wheel hubs or will trade on new 43" TSL for 17" wheel prefer stickys
Also have a bare kingpin chevrolet front housing that is just a couple of inches wider than this rear end that I will let go with it.
James 423-802-6100
Full Float with HP70R 5:13 gear, PowerLock with extra clutches to make it like a spool. Carl Jantz installed the 70 gear set, the ring gear load bolt and the girdle cover.
Axle has not been ran since Jana76 upgrade.
-Approx. 64" WMS
-3/4 ton disk brakes
-Full float
-Yukon forged yoke
-Double splined chromoly shafts
-RockCrusher drive flanges
-New rotors and calipers
-New Solid Axle wheel hubs 8 lug pattern
or
-Used RockCrusher wheel hubs drilled for both 6 lug patter and 8 lug pattern
-Set up for fourlink, coilovers and air bumps
$2800 with new wheels hubs or $2500 with used wheel hubs or will trade on new 43" TSL for 17" wheel prefer stickys
Also have a bare kingpin chevrolet front housing that is just a couple of inches wider than this rear end that I will let go with it.
James 423-802-6100
