Menu
Forums
New posts
Search forums
Calendar
Monthly
Weekly
Agenda
Archive
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Help Support Hardline Crawlers :
Forums
Rock Crawling Forums
Tech & Fab
jd 32 bender iinfo
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Elliott" data-source="post: 276499" data-attributes="member: 1090"><p>Mark the pipe then put that mark at the starting edge of the die, bend a 90, with this you can figure your draw.45's will be pretty close to half this, 180's pretty close to double.I do put multiple bends in a piece but I bend on a verticle bender mostly, they're a lot more accurate for that type of bending.But your main hoops and frame rails, you need to start in the center and work your way out, being careful of which side your going to draw from. 2 degrees of over bend for pipe , 3 degrees of overbend on 1/8" Dom, and 5 degrees of overbend on 3/16" dom is what my bender takes . Just always put your mark on the starting edge of the die and it should always work out for you,</p></blockquote><p></p>
[QUOTE="Elliott, post: 276499, member: 1090"] Mark the pipe then put that mark at the starting edge of the die, bend a 90, with this you can figure your draw.45's will be pretty close to half this, 180's pretty close to double.I do put multiple bends in a piece but I bend on a verticle bender mostly, they're a lot more accurate for that type of bending.But your main hoops and frame rails, you need to start in the center and work your way out, being careful of which side your going to draw from. 2 degrees of over bend for pipe , 3 degrees of overbend on 1/8" Dom, and 5 degrees of overbend on 3/16" dom is what my bender takes . Just always put your mark on the starting edge of the die and it should always work out for you, [/QUOTE]
Insert quotes…
Verification
Post reply
Latest posts
Family Truckster LJ build
Latest: ridered3
Thursday at 5:37 PM
Tech & Fab
M
For Sale
1973 FJ40
Latest: MNboy
Thursday at 3:26 PM
Vehicles For Sale
C
For Sale
1978 J10 Golden Eagle on 43's
Latest: CarolinaCrawler1
Wednesday at 10:24 PM
Vehicles For Sale
For Sale
Single Seat Ultra4 Car
Latest: ridered3
Tuesday at 11:56 AM
Vehicles For Sale
XRock
Latest: ridered3
Jun 10, 2024
Trail Rides & Competitions
Forums
Rock Crawling Forums
Tech & Fab
jd 32 bender iinfo
Top