Menu
Forums
New posts
Search forums
Calendar
Monthly
Weekly
Agenda
Archive
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Help Support Hardline Crawlers :
Forums
Rock Crawling Forums
Tech & Fab
manual reverse valve body th400
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Gittinit" data-source="post: 373841" data-attributes="member: 7985"><p>I haven't checked for line pressure yet, but it does pull great in reverse lol. The shift part referred to above is what were going to check Monday morning to determine whether or not to pull it. It does select each gear per the shifter lever. I dont recall any nail, and am unsure if what your refering to. I definately dont recall bending anything. Just installed the single check ball, springs and ect per the kit instructions from tci. And the cooler lines and all that are all brand new.</p><p>The input was a bit harder to turn after than it was before mrvb install and had me worried all along but was assured by the friend who is helping me that it was OK... now I'll be using his lift to pull it.</p><p></p><p> Killerb468 if your near north east Arkansas please pm me a rebuild price</p></blockquote><p></p>
[QUOTE="Gittinit, post: 373841, member: 7985"] I haven't checked for line pressure yet, but it does pull great in reverse lol. The shift part referred to above is what were going to check Monday morning to determine whether or not to pull it. It does select each gear per the shifter lever. I dont recall any nail, and am unsure if what your refering to. I definately dont recall bending anything. Just installed the single check ball, springs and ect per the kit instructions from tci. And the cooler lines and all that are all brand new. The input was a bit harder to turn after than it was before mrvb install and had me worried all along but was assured by the friend who is helping me that it was OK... now I'll be using his lift to pull it. Killerb468 if your near north east Arkansas please pm me a rebuild price [/QUOTE]
Insert quotes…
Verification
Post reply
Latest posts
I am moving to Tennessee
Latest: Kubotaorange76
Yesterday at 8:48 AM
General Discussion
For Sale
2005 Ford Excursion Eddie Bauer
Latest: jeeptj99
Monday at 11:55 AM
Vehicles For Sale
I.w.i.w clampy
Latest: bobbedrunner99
Friday at 4:44 PM
Tech & Fab
Salvage 10
Latest: ridered3
Friday at 7:47 AM
Tech & Fab
Ultra4 - Battle in Bluegrass (Bowling Green, KY) East Series (4/19-4/20)
Latest: ridered3
Thursday at 12:01 PM
Trail Rides & Competitions
Forums
Rock Crawling Forums
Tech & Fab
manual reverse valve body th400
Top