picking up a rear axle, got some questions.....

[HillBilly_Young01]

im getting a killer deal on a set of axles and have some questions.

the front axle is a dana 44 full width from late 70's model ford f100. the rear axle is a full float dana 60 from a 1980-1988.5 Dodge D-200, W-200, and D-600 with a 3.54 gear ratio. im probably going to be selling the front (got a buyer lined up for it to make my money back off this deal) and using the rear end on my truck.....

so is the rear axle worth keeping or should i sell it off? where can i find info on this axle?

 

[Bones]

It's a stock 60, worth $100 at most to anyone

 

[HillBilly_Young01]

is it worth keeping and building?

 

[CheapJ7]

is it worth keeping and building?

If you want to put 35 splines in it... Cheaper to sell it and build/shave a 14...

 

[COLT]

Sell them off if you can make a buck and get a 14 bolt.

 

[doctordick]

On a Taco with 35's I'd run it unless you plan on building it into a bigtime rockwhomper ;D or you're CheapJ7

 

[HillBilly_Young01]

On a Taco with 35's I'd run it unless you plan on building it into a bigtime rockwhomper ;D or you're CheapJ7

i could only hope to as cool as jon one day

my plan was to use a waggy 44 i built but have since changed directions with the build plan...... im selling off the mild built waggy 44 that i planned on putting under and some other things that i have no need for anymore to get a diamond axle for the front.... fj80 rear e-locked 3rd with either fj80 outters or dana 60 outters. im wanting to run no bigger than a 38.5" tire.

 

[ibrokeit]

FWIW, my factory yota rear is holding up fine on 37's with stock shafts.