Menu
Forums
New posts
Search forums
Calendar
Monthly
Weekly
Agenda
Archive
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Help Support Hardline Crawlers :
Forums
Rock Crawling Forums
General Discussion
Some more driveshaft advice..
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Boonie Buster" data-source="post: 1108514" data-attributes="member: 15974"><p>So I guess now my next question would be should I run singles u-joint at each end? I have been going back and forth on this, and i went and measured some angles and the yotas seem to have really good angles, like i think they'll be adequite for my setup, although I am just concerned about vibrations at higher speeds, Although my buddy has singles on some funky angles on his front shaft and is ok till like 50mph or something... I will have a really good angle for it in the rear, but the front off the t-case is gonna be around 20*-25* working angle...and the bottom about 10* (i think, haven;t really checked...) So I am wondering if I should run a CV up front or not...</p></blockquote><p></p>
[QUOTE="Boonie Buster, post: 1108514, member: 15974"] So I guess now my next question would be should I run singles u-joint at each end? I have been going back and forth on this, and i went and measured some angles and the yotas seem to have really good angles, like i think they'll be adequite for my setup, although I am just concerned about vibrations at higher speeds, Although my buddy has singles on some funky angles on his front shaft and is ok till like 50mph or something... I will have a really good angle for it in the rear, but the front off the t-case is gonna be around 20*-25* working angle...and the bottom about 10* (i think, haven;t really checked...) So I am wondering if I should run a CV up front or not... [/QUOTE]
Insert quotes…
Verification
Post reply
Latest posts
Family Truckster LJ build
Latest: ridered3
Yesterday at 5:37 PM
Tech & Fab
M
For Sale
1973 FJ40
Latest: MNboy
Yesterday at 3:26 PM
Vehicles For Sale
C
For Sale
1978 J10 Golden Eagle on 43's
Latest: CarolinaCrawler1
Wednesday at 10:24 PM
Vehicles For Sale
For Sale
Single Seat Ultra4 Car
Latest: ridered3
Tuesday at 11:56 AM
Vehicles For Sale
XRock
Latest: ridered3
Monday at 10:38 PM
Trail Rides & Competitions
Forums
Rock Crawling Forums
General Discussion
Some more driveshaft advice..
Top