bdillon2372
Well-Known Member
So, it's been awhile since I've raced this buggy and I have realized that I am not going to race anymore, I have started a new company and just do not have the time nor the funds for that anymore so I have finally made up my mind to sell, I MAY BE OPEN TO PARTIAL TRADES, I am interested in a no frills bass boat, nothing fancy, just something that my son and myself can get out on the water with and do a little fishing.
*Fully TIG welded single seat chassis built by DirtySouth Motorsports
*118" wheelbase
*502 c.i. BBF (740 hp est tuned by "Fish")
*Custom aluminum air intake (breaths from inside cockpit)
* Autometer gauges (tach, oil, water, volt, trans)
*Holley EFI dominator series
*MSD 6al ignition /150 amp alternator /Tilton starter
*PSC steering pump /double end ram
*Remote oil filter
*All plumbing braided stainless w/ AN fittings
* Canton 3 qt. Accusump oil accumulator w/ solenoid
*Meziere Electric water pump
* 8 groove serpentine system/ custom pullies/ brackets
* Fox remote res. 2.5 coilovers/ King bump stops front
* Dana 80's F & R retubed w/ 1/2" wall, custom trusses
*4:10 gears
*Wide Open Design "Bad Ass" C's and knuckles
*2" Aluminum upper/lower links w/ 1 1/4" heims
*Wilwood hats and drilled rotors
*Wilwood 4 piston race calipers
*Ouverson Super 8 billet aluminum Hubs
*RCV 2" 300m 47 spline axle shafts F&R inners and outers
*C-6 trans built by Ed at PTC
*Heat Exchanger trans cooler
*PTC converter
*reverse manual valve body
*Dirt track shifter w/ stop pin for slamming reverse ;D
* 3:1 HERO case
*1480 drive shafts F&R (comes with extra shaft, fits both front and rear)
*43" TSLsx stickies on forged Racelines, w/ custom beadlocks rings
*custom aluminum fuel cell (holds about 8 gal)
*All wiring w/ weatherproof connectors
*Full UHMW bottom skid plate w/ UHMW side skids
*PRP seat / G-Force Harness
*3800 lb Dry weight
Probably forgetting some stuff. This buggy was built to race and is race ready.
Buggy is currently located at Pete's shop in Lindale GA but I will be bringing it back to Soddy Daisy TN in next week or so (whenever I can get freed up)
ASKING $62,000.00, REASONABLE OFFERS WILL BE CONSIDERED, PLEASE NO LOW BALL OFFERS
Please PM me on here or send me a message on Facebook, I ONLY CHECK FB AT NIGHT.
Will attempt to get some better pics on here ASAP
*Fully TIG welded single seat chassis built by DirtySouth Motorsports
*118" wheelbase
*502 c.i. BBF (740 hp est tuned by "Fish")
*Custom aluminum air intake (breaths from inside cockpit)
* Autometer gauges (tach, oil, water, volt, trans)
*Holley EFI dominator series
*MSD 6al ignition /150 amp alternator /Tilton starter
*PSC steering pump /double end ram
*Remote oil filter
*All plumbing braided stainless w/ AN fittings
* Canton 3 qt. Accusump oil accumulator w/ solenoid
*Meziere Electric water pump
* 8 groove serpentine system/ custom pullies/ brackets
* Fox remote res. 2.5 coilovers/ King bump stops front
* Dana 80's F & R retubed w/ 1/2" wall, custom trusses
*4:10 gears
*Wide Open Design "Bad Ass" C's and knuckles
*2" Aluminum upper/lower links w/ 1 1/4" heims
*Wilwood hats and drilled rotors
*Wilwood 4 piston race calipers
*Ouverson Super 8 billet aluminum Hubs
*RCV 2" 300m 47 spline axle shafts F&R inners and outers
*C-6 trans built by Ed at PTC
*Heat Exchanger trans cooler
*PTC converter
*reverse manual valve body
*Dirt track shifter w/ stop pin for slamming reverse ;D
* 3:1 HERO case
*1480 drive shafts F&R (comes with extra shaft, fits both front and rear)
*43" TSLsx stickies on forged Racelines, w/ custom beadlocks rings
*custom aluminum fuel cell (holds about 8 gal)
*All wiring w/ weatherproof connectors
*Full UHMW bottom skid plate w/ UHMW side skids
*PRP seat / G-Force Harness
*3800 lb Dry weight
Probably forgetting some stuff. This buggy was built to race and is race ready.
Buggy is currently located at Pete's shop in Lindale GA but I will be bringing it back to Soddy Daisy TN in next week or so (whenever I can get freed up)
ASKING $62,000.00, REASONABLE OFFERS WILL BE CONSIDERED, PLEASE NO LOW BALL OFFERS
Please PM me on here or send me a message on Facebook, I ONLY CHECK FB AT NIGHT.
Will attempt to get some better pics on here ASAP