Sold/Expired Toyota V6 3Rd

[84turbotoy]

Toyota v6 3rd member, I think 308 is what I came up with on gear ratio. Also have housing and axles if you need the complete setup. 75 for the chunk

 

[84turbotoy]

bump

 

[84turbotoy]

Bump for hawk pride tomorrow! 12-29-12!!! obo

 

[84turbotoy]

Weekend bump

 

[84turbotoy]

Haven't bumped this since last year :****: Offers?

 

[TBItoy]

Haven't bumped this since last year :****: Offers?

That must be from a 2wd v6 truck or something, the outer casting looks like a V6 3rd, but the carrier is a 2 pinion (single cross pin) instead of the usual "clamshell" 4 pinion carrier found in v6 3rds.

Can you measure the carrier bearing size? I'm curious if it's 50mm journal or a 45mm.



The Hi pinion 8" fronts use a carrier like this (2 pinion, single cross pin, 50mm "v6 carrier bearings")

 

[84turbotoy]

I will check and see Nick, It came in the rear of my 84 solid axle and I knew something wasn't right when I put it in 4 low and ended up with this so any help would be appreciated.

 

[TBItoy]

I will check and see Nick, It came in the rear of my 84 solid axle and I knew something wasn't right when I put it in 4 low and ended up with this so any help would be appreciated.

What gears are you running? I have a several spare sets of 4.10 on the shelf if you wanted to regear it.

 

[84turbotoy]

I swapped back to the 4cyl housing for ease of same pumpkins, always carry a spare to the park incase I pop one! :****:

 

[84turbotoy]

bump

 

[84turbotoy]

bump