T tommyswheelin Well-Known Member Joined Dec 21, 2011 Messages 230 Aug 1, 2012 #1 Fixing to buy some good joints. Who has ran them? Has anyone broke a nitro 300m u joint. ? What's y'alls input?
Fixing to buy some good joints. Who has ran them? Has anyone broke a nitro 300m u joint. ? What's y'alls input?
Jhouser Well-Known Member Joined Dec 4, 2009 Messages 171 Location Columbia, TN Aug 1, 2012 #2 I was told they had a problem with them gaulding up and thats not covered under warranty. YUKON SUPER-Joints are my pick.
I was told they had a problem with them gaulding up and thats not covered under warranty. YUKON SUPER-Joints are my pick.
wizzo Well-Known Member Joined Dec 5, 2007 Messages 1,988 Location glasgow, ky Aug 1, 2012 #3 CTM's or Yukon super joints
crawlin85cj Barco Motorsports Joined May 24, 2011 Messages 857 Location Forney, TX Aug 1, 2012 #4 Ouverson Violators are the beefiest joint I've seen. They have been great for me.
payne97 gas the **** out of it Joined Mar 30, 2010 Messages 1,220 Location Yankeeland Southeren IN Aug 1, 2012 #5 crawin 85cj what axles do you run
crawlin85cj Barco Motorsports Joined May 24, 2011 Messages 857 Location Forney, TX Aug 1, 2012 #6 I have a set of Violators in clearanced Superiors from Branik and a set in Spidertrax 300M shafts.
T texasag02 Active Member Joined Aug 27, 2010 Messages 30 Aug 1, 2012 #7 I run them, just keep them lubed and you are good to go :afro:
Rockwells607 Well-Known Member Joined Feb 18, 2010 Messages 1,758 Location corning ny Aug 2, 2012 #8 I too am running nitro 300m joints in my smith buggy right now, no issues, i just grease them every time out with high carbon grease....
I too am running nitro 300m joints in my smith buggy right now, no issues, i just grease them every time out with high carbon grease....
snoball Well-Known Member Joined Mar 23, 2011 Messages 391 Aug 2, 2012 #9 Ran them in a 44 and 60 with not one problem. Broke many axles but never a joint.
C CCOR 706-559-9609 Joined May 29, 2009 Messages 555 Location Athens, GA Aug 4, 2012 #10 There was a thread on pirate where they tested them and found out they actually were not 300m
E electrican Well-Known Member Joined Jun 27, 2010 Messages 236 Aug 9, 2012 #11 running the nittro joints and have never broke one of them. Broke a inner and outter at the same time and the joint was still good. Just make sure and grease them regular.
running the nittro joints and have never broke one of them. Broke a inner and outter at the same time and the joint was still good. Just make sure and grease them regular.