CHOP SHOP
Well-Known Member
Are you going to be at the CORE Challenge? :corn:
Last time they had bumper to bumper pull offs.
Can I pull your bumper off?:corn:
Are you going to be at the CORE Challenge? :corn:
Last time they had bumper to bumper pull offs.
If my junk is there and your junk is too, lets do it :corn:
The stomper is going to drag you all over the place.
Brad has the advantage, his truck is heavier, and he has 2 1/2 ton axles and bigger tires. If my junk doesn't break doing the mudbog, rocks and tuff truck course, it will be fun hooking bumper to bumper.
![]()
That was on sheet metal. I left the machine/POS way up from an earlier project. It is spooled up with .035 wire. I then just stitch welded to get that stacked dimes look that folks like. Its actually a shitty cold row of spot welds good for not much more than shavin door handles. :redneck:
I usually have my ancient machine cranked up and weld hot. Its a POS from the 70s. It contains no circut boards or electronics, just a power supply and a feeder motor. Basicly the same setup as a diesel arc welder and a feeder suitcase and gas, just in one box. I need to get a new machine someday.:awesomework:
SLACKER!!!!!
How dare you leave all these WEBWHEELERS hanging!!!???!!!:stirpot::haha:
I think he thought long and hard about it....
and started over:flipoff:
hey bunk, there is some truth in what your sayin. I am going to build a different chassis after this things done. I just wanted to learn a little more good and bad about link setup before I build a full tube roller.
I think it would be a ton easier to build fresh from tube than to build around ten different phases of a rig that has been redone a million times.
The nice part is I can build a chassis on the table and just transfer all the parts over and be good to go. I just dont have the time to do it now without waiting for a couple years to wheel it. I can have this in the woods fairly quickly with whats left.:awesomework:
I have never wheeled a buggy before and an going to use this as a learning platform, not a lifelong dream build!![]()
:awesomework:updates fag hater. :cheer:
here ya go. :kissmyass:
asshat.:looser: Wheres the pics of your welds?:corn: Not your buddies.:fawkdancesmiley:
The lower links are going to be "unbendable".:flipoff:
:haha:
x2 :haha::haha: