Recent content by briejer

Who can I find to machine a slot for a woodruff key in a 3/4" axle shaft thats in the south sound area? This is for an ultralight

I have no input on gas tanks. I do have input on auto trans. If you run a stock dipstick make sure to get a newer model one that is sealed well, or you will spill on roll overs. My constant issue was with the auto trans vent. I had issues driving no my side and super steep climbs. Believe it...

Start with Amazon. http://www.amazon.com/Impco-Adapter-Rochester-Barrel-Quadrajet/dp/B00EP1OWU4/ref=sr_1_fkmr1_3?ie=UTF8&qid=1454091817&sr=8-3-fkmr1&keywords=impco+4barrell+adapter

Like it was said, an axle cut off and splines welded on. What I did not like is that the U-joint was welded on the axle shaft side of the driveline. What I did on my last driveline was have a 1350 yoke from a t-case welded onto a old axle shaft(14 bolt). This way I had serviceable u-joints...

The good about the KLR650 is it's reliability and its fuel range and CHEAP. A low compression motor and a big fuel tank makes that possible, but it is a ****ty bike for any performance. Ridding one is like putting around on a XR75. There is really no cure for the low power, but other bikes...

The negative on the coil HAS to go to the negative plug on the distributor. This tells the coil when to spark. The coil has a negative and a positive plug. Your picture has the negative coil grounding to the body/block/engine. That WILL NOT work.

My main issue when setting up propane was freezing the regulator. I suggest starting it on gasoline(spray bottle in the mixer) get it fired up and bleed the air out of the coolant. Flooding a propane system is also common.It happened often with my techno carb rip off set up. Since its a vapor...

I'm looking forward to rolling it for you. Dont worry , the first one will be gentle

Back when I used to wheel, I tried a set of Irok Radials. Worst sidewalls ever. I ripped, punctured all 4 , multiple times. Never again

Mount that **** up soilid. Why would you need rubber or poly mounts for a 150 pound tub. Burn that **** on soild.

Been a few years since I've wheeled Rimrock. Had some fun trips in the past with a few of you. What are the thoughts of getting into the land of the dust for a weekend? Robin

The outer lugs pull the tire toward the obstacle(rock, root ect.) instead of spitting you off the line. It made it easier to hold a line.

Last I heard is that all the bolts have been stripped. The route was put up illegally and no longer exists. edit.....I could be wrong....

After my wrist and femur heal I hope to back into climbing. I'm hoping for June/July. If your game I should be up to leading traditional sustained 10's and easy 11's. I have eneough gear to climb anything. We should get a few of us to climb the Davis/Holland.

What difficulty are you climbing?