Recent content by monsterjeep44

Back to the top for a good Christmas Project.

I have a 95 Jeep Wrangler that the body has been boat sided with 1 1/2 X .120 wall tubing, run all the way around the bottom of the body. One ton axles, Dana 60 Front new king pins, locking hubs. 14 bolt, Rear ARB Air locker, both have 456 gears. Rear has been 4-linked with 2" 7075 Alum bars and...

Back to the top.

ttt

I have a 95 Jeep Wrangler that the body has been boat sided with 1 1/2 X .120 wall tubing, run all the way around the bottom of the body. I have two fiberglass tops, plans were to combine to make one four door, I have the full 4 doors and 4 half doors. One ton axles, Dana 60 Front new king pins...

:driving:

bump

It is set up for a vortec 350. I built a 383 stroker motor to put in it with a 700r4 trans and a 205 transfer case.

bump

Yes I do...would you like to take a look?

The wheel base is 138''.

:dblthumb:

I have a 95 Jeep Wrangler that the body has been boat sided with 1 1/2 X .120 wall tubing, run all the way around the bottom of the body. I have two fiberglass tops, plans were to combine to make one four door, I have the full 4 doors and 4 half doors. One ton axles, Dana 60 Front new king pins...