Anyone know of a shop to help with a few bumper projects? Loftis cuts but doesn't bend. I've used a shop out of state before, but it would be great to find someone local for projects like this. I have drawings and dimensions - just looking for a local shop for steel cut/bend services
<reposting in the correct sub-forum>
Swapped a set of factory locked axles into my LX450 and have these available. 179k miles from a 1997 - full floater rear, high pinion front, 4.10, etc. No calipers, but otherwise ready to roll. Have rear rotors, not pictured. $800. Pick up in Nashville -...
Swapped a set of factory locked axles into my LX450 and have these available. 179k miles from a 1997 - full floater rear, high pinion front, 4.10, etc. No calipers, but otherwise ready to roll. $800. Pick up in Nashville - bring muscles and strong backs!
It's hard to quantify. I figured that new trucks with 800ft-lbs of torque use this setup on the rear axle, so it should have some positive results on a crawler front axle. All I know is that this Jeep works extremely well on the trails, and that's good enough for me!
No problem. I'm in no rush to sell it. I'd like to get one more ride in it this fall!
Also, had a few questions:
- No AC/heat/radio. All removed for weight and simplicity
- All lights, turn signals, etc work
- Has dedicated power steering and tranny coolers
- 79.5" overall height
I'll post...
Well.. Just not using this enough to justify it sitting in the garage. Light weight, dead reliable, simple YJ Crawler for sale.
1994 with clear title, 113k miles
4.0 engine
999 auto tranny with Art Carr shifter tied to cage
241OR Rock-Trac transfer case, 4:1, 32 spline outputs
79 Ford High...
Started a project that never got finished. Complete 14 bolt, 8 lug, full-floater with 4.56 gears, Detroit, and disc brakes. Some work on starting a truss. 8 lug roller tires/wheels included.
Located in Nashville. First $650 takes it home.
Thanks
Thanks, but I have a set of H2s in the garage - They have about 5 5/8" backspacing which I like, but I'm deciding on whether or not I want to mess with internal beadlocks on them.