Search results for query: *

Ran across these on another forum, sure someone will find it useful. http://www.tubebandit.com/xcart/

Does a Toyota pump care what direction is up? Does the feed need to be pointed up, pressure line down? or vise versa? or both horizontal? Thanks, James

I'm trying to find a common hyd clutch setup (master cyl and slave). I've looked at a willwood style setup but would rather have something that might be easier to get off the shelf. This setup is for a CJ-5, SB Chevy and a NP435 4sp. Thank you,

Can I make the stock '88 Chevy TBI work with a ZZ4 (355hp) engine? Got a friend with the zz4 sitting in his shop, I got an '88 Blazer (350/210hp) in need of a non-smoking engine. I know the chip will have to be changed, I'm also thinking the injector will probably need to be bumped up, any...

After last weekend I've decided that GPS would be good to know and have. Not knowing much about it any suggestions on what to looking for in a unit?. Want something for the trail, large screen, and finding my way in a different city would be nice too.

It's been a while since wheeling with a carb and I suck at carbs anyway. Is the carb any good for wheeling? The carb on it right now is a Holly of some sort on a Edelbrock SP-2P intake, old school. Thank you.

Anybody know if the scout T-90 is the same bolt pattern as the Jeep T-90? Know the Xfers are interchangeable but not sure about the input shaft and front trans bolt pattern. Reason I'm asking is a Jeep I'm looking at has a bad trans but I know were two Scouts are just sitting. This would get...

Anybody know were to get a tool for removing the upper "king pin"? I used a piece of 7/8 stainless steel hex but just twisted the SS.

The OD was taken out of a '70 2wd and says "Warn aux trans 3343". The OD was bolted to the back of the trans and uses an extra long output shaft. Anybody know anything about these or were to find info on it?

It's been a while but finally I'm getting a shop. After a few snags, first hole they started 16" down a pipe showed up. This pipe happen to an abandon steam line, so a sawall made quick work but not a good way to start. The drawings SUCK too, dimensions don't add up and notes that aren't...

Are scout 4cyl and 8cyl flywheels interchangable? I know they bolt on but a friend went to fix a leaky seal and found out he has a 4cyl flywheel on a 345.

Anybody run one of these? Thinking of using them but can't really find anybody but mag that have used them. any problem? soleniods? switch? locker it's self? Are they instant engage, or does the wheel have to turn 1/2? 1/4? Just general if you liked them or not.