Search results for query: *

If anyone can rebuild this for my stepfather or knows of a good shop to do the work, I'd be very grateful. Here's the skinny: 1987 Toyota 5 speed, 22R engine, 4x4 I have the VIN if that will help anyone. So - let me know your opinions on local shops you all have used, please, or if you can...

Anyone have one of these? Diacro bender model #DB8073 I'm presuming that it's like these models: http://www.diacro.com/diacro_products/diacro_power_bender.html However, I've not seen it just yet so wanted to check to see if anyone has one that I can see pictures of so that I know what...

I'm rebuilding an SM420 4 speed. Having followed the directions from Novak with their kit, i'm starting a what I believe to be a properly assembled transmisison, but I can't seem to make first or 4th. work correctly.. I'll post pictures tomorrow. Is anyone here good with these transmissions...

Looking for a good used press, anyone know of where I can get one? Thanks! Brett.

I tried to buy parts for my parts washer the other day, but they had just been acquired by SafetyKleen and were not selling individual parts at that time. I found the pump I needed on eBay (Little Giant), but it's not 100% match. Who do you folks use to service your Parts Cleaners?

So I'm working over a pair of Dana 44's from a 1976 Wagoneer that had the Quadra-Track case. I got the carrier out and have been trying to get the bearings off the carrier - granted, they've been on there for.. oh wait.. *math* 30 YEARS or so!!! I finally wound up using a bearing puller to...

Does anyone know where to rent one? I plan to ask Schucks or Napa if they rent them, but since they seem pretty pricey and somewhat rare to use other than in professional settings - I'm not sure I'll find one? Thanks for any direction. Brett. :beer:

Following up on this thread: http://www.nw-wheelers.com/forum/showthread.php?t=16070&page=3 Let's see where and how folks mount their High Lifts. In this case, I took the 7" raised mount from the previous thread - which was intended to be front-bumper mounted (On the TOP) and used it behind...

I've wanted to figure out how to mount my Hi Lift jack on the bumper of my Jeep for awhile, but everything that I found would not clear the Winch on the front, or had some other limitation. I did recently find these folks: btbproducts who make a very clever 5" and 7" raised mount for your Hi...

I've got a set of Dana 44's from a Wagoneer specific to the Dana 18 transfer case. '74 to '76 vintage :) The inside of the disc for the front indicates that it's good down to 30.86 MM and right now it's got about 33 MM total width on the disc. From a "getting the rotors turned" perspective...

You can get quality maps that are well-detailed from REI and a few other outlets by these folks: http://greentrailsmaps.com/ Good peeps - order the series for where you wheel/hike and you won't regret it :cheer: