Search results for query: *

BeBop you need RCV wheel studs.....

But we have 2 and 3 liter cokes...

I put my master power switch between my seats for easy access, the switch lever also serves as a key, when off you can take it out.

I have used these twice, super simple because they come already assembled and wired!

.

Might be easier to just buy aftermarket speedo with built in gps, I know they make them for boats.

I'm just glad I know people with money....

I would, but absolutely don't have the room, I have the reverse mount master cylinders that are under the dash

I have 2lb residual valve's on both master cylinders..,

Man, I'm going to watch this thread, I have the same calipers, with dual 3/4 Wilwood master cylinders, I have bled at least a quart of fluid through each one, have no pedal! You can pump it up several times and it's ok, let it sit for 10 seconds, and it will go to floor, driving me nuts

Thanks guys for the input, that's what I was hoping to here.

Anyone ever use one of these? Any good? Trying to get finished up on my build, I have a low pinion GM 60 front, I have a 2 piece front driveshaft, the shaft from t case to carrier bearing is level, then the other shaft is at a downward angle to front end, but the problem I'm going to have is...

Is the 4 barrel kicking in??

Carbs just can't handle bouncing around and steep hills, it will be constantly flooding, so unless your just dirt road riding, go propane or efi and just be done with it.

I swear! This dude is my hero! Party's all the time, lives by the river, has a dime piece lady, and a kick ass buggy.

Knowing you, you probably had vintage A/C and heat installed Sent from my Moto Z (2) using Tapatalk

And the good thing about PTC building it, they run it on a Dyno to check for all pressures and leaks, that means a lot there, especially the pain in the ass it is to take them in and out.

But you sir have a precision assembly line built buggy, so it should not require any redoing..... :flipoff1:

Think it will hold up to a ls engine with a cam and hot tune?

Looks like there is a terrorist from the Middle East riding shotgun! :JRich: