baldduck74
Well-Known Member
- Joined
- Oct 19, 2013
- Messages
- 352
While waiting on new bearings an seal's to replace my roasted range box, I decided to look at my home built shifters. Got to noticing at Harlan my front drive would just slip out, and be in rear drive only, usually in a not under power situation, same thing with the 203 range box lever.
My shifters have cheap ACE hardware ball bearings in a piece of homes out 3/16" dom for pivots on a 5/8" bolt.
A
. And I'm wondering if I'm no creating enough tension on levers to help hold them in place. High low side on 205 is fine.
Sent from my XT1650 using Tapatalk
My shifters have cheap ACE hardware ball bearings in a piece of homes out 3/16" dom for pivots on a 5/8" bolt.
A
Sent from my XT1650 using Tapatalk