Sold/Expired 4.3/sm465/ott adapter/crawlbox/crashfab adapter(dana300)

[crash2]

Ok so my new rig is about to start so its time to change and got a bunch of goodies...

 

[crash2]

sold




First part--4.3 TBI. It has always ran great and no noise. I have always ran mobile 1 in it.

What it has
1-centerforce 3 clutch thats never slipped and never got it hot--I believe its a 10" clutch.
2-Has all sensors and ever a heated o2 (never has a heated unit on this series of motor)
3-Is setup to use a york compressor--comes with the mount and proper belt(need to run a york with a serpentine pully)
4-Has a cleanable air filter with stock housing.
5-Wiring harness is all there but will need to be reworked a little to fit your needs.
6-ONLY problem with it is smokes on startup--needs new valve guide seals replaced--has since I got it,lol...

$300

 

[crash2]

sold



Sm465 with aluminum bell housing (chevy bolt patter)

The shifter is setup to run in a toyota. It has the 10 spline output and a functional reverse light switch.
It comes with the slave bracket that I made to fit an fj slave and has the cast clutch fork.

Only flaw in it is there is a small crack that happened 7 years ago from front driveshaft contact--never has gotten worse since then. Also always ran redline synthetic in it and replaced all the roll pins in the shift gate assembly a few years ago.

$125 and $20 more for the fj clutch master and slave with line.

 

[crash2]

OTT sm465(10 spline) to toy(21 spline) transfer case adapter.

This thing is burly and has 2 clock-able positions. Never ever given me any problems. Comes with all mounting hardware

$325

 

[crash2]

Toyota doubler.

21 spline input with marlin adapter and AA 4.7 gear inside the case.

Always ran redline synthetic fluid in it.

$700

 

[crash2]

Last piece is an adapter that I built (this was on in 7 that I did). This goes from a toyota doubler adapter to a dana 300 transfer case. Its clocked so the 300 is damn near flat. The adapter also incorporates the cross member into it and also comes with the adapter. It comes with all mounting hardware

**this adapter us made to work with any of the dual case adapters.

$200

 

[1982cj7]

I will take the trans and bellhousing, I am still thinking about the engine.

 

[1982cj7]

I will take the engine also Crash. I cannotdrive yet so I will have to get some one to bring me out to get them. it will be by next weekend.

 

[crash2]

I will take the engine also Crash. I cannotdrive yet so I will have to get some one to bring me out to get them. it will be by next weekend.

If ya want them just let me know when and before somebody else snags them :awesomework:

 

[1982cj7]

What is the best time to come out to get them?

 

[crash2]

What is the best time to come out to get them?

Any night after 6 and if its rainy saturday

 

[1982cj7]

We will be out this evening, what is your address or directions?

 

[crash2]

sent ya pm :awesomework:

 

[1982cj7]

Thanks Crash for the engine and trans, let me know if you are going to use the headers or not I Might be interested in them.