Welderd
Well-Known Member
- Joined
- Jan 16, 2008
- Messages
- 998
Engine
92 22re
Davez trimmed buggy wiring harness
Hi-amp Chevy alt.
stock AC compressor for on-board air (5gal tank?)
Trans
R151F
Tcase
Marlin Dual ultimate
23spline throughout
stock front gears
4.7 rear gears
Longfield output
Driveline disconnect
twin sticked
Axles
Dodge D60 front Kingpin 67" WMS-WMS
5.38 gears
ARB
35spline chromo
CTM's (just rebuilt)
3/4 disc (fits 15's, same brakes front/rear)
35 spline drive slugs
Rear 14bolt 5.38 ARB 3/4T discs stock shafts
yota flanges on both
tom woods driveshafts with custom 2 piece
Suspension
2" Fox Airshocks
14" travel
7075 links
front upper is smaller diameter steel
3 link front with panhard
4 link rear
All 7/8" RH heims (common spares)
Tires/Wheels
39" Red label Krawlers
just getting worn in right
H2 rims
Inner Airlocks
Flush Mount Valve Stems
set of 5
Chassis
twisted custom styling built by me and a buddy
1 5/8" DOM
Stock sami frame rails - completely cleaned and plated
7075 roof
both lexan and AL side panels
Misc
8k winch with rope
Griffin Radiator with fan and shroud
cutting brakes for rear
chevy master cylinder
front line lock
Stock sami windshield will bolt on
amp and 6x9 speaker with MP3 connection
EMPI front seats
Rear TJ flip and tumble seat
5pt 3" front harnesses
one rear 2" 5pt harness
one rear lap belt
all belts quick pin double shear to move around quickly
multiple latch locations for car seat attachments
car lap belts on rear cargo area for securing cooler and tool box
3 quick disconnect fire extinquishers (1-5lb, 2- 2.5lbers)
rear tire carrier with 4way
hi-lift jack and mount
optima battery
dual battery disconnects
rocklights
spares
Stock knuckles
front and rear d-shafts are interchangeable, multiple spares
spare mid shaft
spare front axle shafts (35spline chromos, some stock too)
spicer life axle joints
One spare long travel driveshaft is mounted on rig under rear seat
3 spare gallon fluid containers mounted behind rear seat
spare drive slugs
spare rear axle shafts
spare alt
spare fuel pump (electrical connector broke)
spare tie rod ends
AC compressor (on-board air)
23spline t-case
output shaft
links and heims (mount for spare link under rear seat)
hydraulic hoses
full nylon brake kit for emergencies
I built this thing with my kids safety in mind and didn't want anything to happen while they were with me to make the trips memorable and not a pain in the ass. It's super reliable and tough. If anything goes wrong on this buggy or your buddies rig there are enough tools and parts tucked away on it to get you back safely and quickly.
Titled as a 1987 Suzuki Samurai
In MO I have historic tags and can get insurance
working on lights to make street legal
Life changes - everything listed - asking 18,000 obo
If you want it for less I can swap out some good parts for cheaper stuff
Located in Troy, MO
contact Travis 314.402.seven three four two
92 22re
Davez trimmed buggy wiring harness
Hi-amp Chevy alt.
stock AC compressor for on-board air (5gal tank?)
Trans
R151F
Tcase
Marlin Dual ultimate
23spline throughout
stock front gears
4.7 rear gears
Longfield output
Driveline disconnect
twin sticked
Axles
Dodge D60 front Kingpin 67" WMS-WMS
5.38 gears
ARB
35spline chromo
CTM's (just rebuilt)
3/4 disc (fits 15's, same brakes front/rear)
35 spline drive slugs
Rear 14bolt 5.38 ARB 3/4T discs stock shafts
yota flanges on both
tom woods driveshafts with custom 2 piece
Suspension
2" Fox Airshocks
14" travel
7075 links
front upper is smaller diameter steel
3 link front with panhard
4 link rear
All 7/8" RH heims (common spares)
Tires/Wheels
39" Red label Krawlers
just getting worn in right
H2 rims
Inner Airlocks
Flush Mount Valve Stems
set of 5
Chassis
twisted custom styling built by me and a buddy
1 5/8" DOM
Stock sami frame rails - completely cleaned and plated
7075 roof
both lexan and AL side panels
Misc
8k winch with rope
Griffin Radiator with fan and shroud
cutting brakes for rear
chevy master cylinder
front line lock
Stock sami windshield will bolt on
amp and 6x9 speaker with MP3 connection
EMPI front seats
Rear TJ flip and tumble seat
5pt 3" front harnesses
one rear 2" 5pt harness
one rear lap belt
all belts quick pin double shear to move around quickly
multiple latch locations for car seat attachments
car lap belts on rear cargo area for securing cooler and tool box
3 quick disconnect fire extinquishers (1-5lb, 2- 2.5lbers)
rear tire carrier with 4way
hi-lift jack and mount
optima battery
dual battery disconnects
rocklights
spares
Stock knuckles
front and rear d-shafts are interchangeable, multiple spares
spare mid shaft
spare front axle shafts (35spline chromos, some stock too)
spicer life axle joints
One spare long travel driveshaft is mounted on rig under rear seat
3 spare gallon fluid containers mounted behind rear seat
spare drive slugs
spare rear axle shafts
spare alt
spare fuel pump (electrical connector broke)
spare tie rod ends
AC compressor (on-board air)
23spline t-case
output shaft
links and heims (mount for spare link under rear seat)
hydraulic hoses
full nylon brake kit for emergencies
I built this thing with my kids safety in mind and didn't want anything to happen while they were with me to make the trips memorable and not a pain in the ass. It's super reliable and tough. If anything goes wrong on this buggy or your buddies rig there are enough tools and parts tucked away on it to get you back safely and quickly.
Titled as a 1987 Suzuki Samurai
In MO I have historic tags and can get insurance
working on lights to make street legal
Life changes - everything listed - asking 18,000 obo
If you want it for less I can swap out some good parts for cheaper stuff
Located in Troy, MO
contact Travis 314.402.seven three four two
