DRocKs XJ Active Member Joined Dec 14, 2010 Messages 35 Dec 20, 2011 #1 Has anyone built one of these axles? and Has anyone had any problems with them?
B broncomike Blount County Al Joined Oct 23, 2011 Messages 347 Location Blountsville Al Dec 20, 2011 #2 I got one the other day. Only thing herd bad is that the tubes might spin in housing. I am goining to drill and tap and put in some 3/8 grd 8 bolts.
I got one the other day. Only thing herd bad is that the tubes might spin in housing. I am goining to drill and tap and put in some 3/8 grd 8 bolts.
smittybronco Well-Known Member Joined Nov 26, 2011 Messages 82 Location clyde,nc Dec 20, 2011 #3 I got one in my bronco that I welded the spider gears with 4.10s I got a 460 witha 4spd no problems....
I got one in my bronco that I welded the spider gears with 4.10s I got a 460 witha 4spd no problems....
RHINO660 TUSCALOOSA AL. ROLL TIDE !!!!!!! Joined Jan 19, 2010 Messages 1,091 Location TUSCALOOSA AL. Dec 20, 2011 #4 i got one welded with 4:88 gears chep if any body needs one there are strong
Do Work 93YJ Well-Known Member Joined Nov 11, 2009 Messages 457 Location East of ATL Dec 20, 2011 #5 I run a sterling welded tubes,welded spiders, 5:38 gears and no problems other then I hate how low the calipers hang. Sent from my iPhone using my right hand.
I run a sterling welded tubes,welded spiders, 5:38 gears and no problems other then I hate how low the calipers hang. Sent from my iPhone using my right hand.
smittybronco Well-Known Member Joined Nov 26, 2011 Messages 82 Location clyde,nc Dec 20, 2011 #6 I hate to hack this thread but has anyone shaved the 10.25? Im fixin to do mine and was just wandering
I hate to hack this thread but has anyone shaved the 10.25? Im fixin to do mine and was just wandering
B broncomike Blount County Al Joined Oct 23, 2011 Messages 347 Location Blountsville Al Dec 20, 2011 #7 I am thinking about cutting the extra iron trus off the bottom . But havent yet .... You first!
smittybronco Well-Known Member Joined Nov 26, 2011 Messages 82 Location clyde,nc Dec 20, 2011 #8 Im just goin to cut mine straight across the bottom and leave about a 1/2in gap between the plate and ring gear
Im just goin to cut mine straight across the bottom and leave about a 1/2in gap between the plate and ring gear