So I've installed LED Tail lights on my 81 toyota and everything seems to work fine, except when I turn on either blinker in the cab, both of them flash.
I am using truck lite brand 60 series (oval) three wire lights(One for Turn/stop, one for tail, and one for ground)
WTF?!?!?!
I'm seriously frustrated and have been searching the interwebs for over 2 hours now and haven't found anything to help.
The only thing I can think of is that since the brake lights in the factory harness use one common ground all the way to the back, and that since the trun and stop are spliced into the same wire at the light, that power is back feeding through the connected brake circuit and making both sides blink whenever I use one or the other.
What do I need to do?
Would adding a resistor in the blinker power wire before it meets the brake power wire do anythign for me?
I am using truck lite brand 60 series (oval) three wire lights(One for Turn/stop, one for tail, and one for ground)
WTF?!?!?!
I'm seriously frustrated and have been searching the interwebs for over 2 hours now and haven't found anything to help.
The only thing I can think of is that since the brake lights in the factory harness use one common ground all the way to the back, and that since the trun and stop are spliced into the same wire at the light, that power is back feeding through the connected brake circuit and making both sides blink whenever I use one or the other.
What do I need to do?
Would adding a resistor in the blinker power wire before it meets the brake power wire do anythign for me?