question...

[yota8]

Do I need their inner cs to run those knuckles or can I just use my stock ones off my balljoint d60?

http://www.dynatrac.com/products_prorock60forknuckles.html

-Mike :awesomework:

 

[pokey]

Lets read from their website shall we.....

The Dynatrac Pro 60 End Forging and Outer Knuckle are designed to work with all ball-joint style, Dana 60 front axle assemblies. End Forgings can
be machined or sleeved to fit different OD axle tubes.

*Note: End Forging and Outer Knuckle can be purchased individually
or as a set.


Somewhat confusing but it does seem to say that the outer knunckle can be used with any balljoint axle. I would call them and ask before shelling out the $$$

 

[yota8]

Lets read from their website shall we.....

The Dynatrac Pro 60 End Forging and Outer Knuckle are designed to work with all ball-joint style, Dana 60 front axle assemblies. End Forgings can
be machined or sleeved to fit different OD axle tubes.

*Note: End Forging and Outer Knuckle can be purchased individually
or as a set.


Somewhat confusing but it does seem to say that the outer knunckle can be used with any balljoint axle. I would call them and ask before shelling out the $$$

Thanks, time to fork out money after i call them :booo: